NBC177BS00 - Refrigerator NewAir - Free user manual and instructions

Product Type	177-Can Beverage Cooler
Brand	NewAir
Model	NBC177BS00
Storage Capacity	5.3 cubic feet
Dimensions (W x D x H)	23.4" x 22.4" x 33.0"
Product Weight	104 lbs
Shipping Weight	113 lbs
Power Consumption	90W
Voltage / Frequency	110-120V ~ 60Hz
Current	1.2A
Temperature Range	36°F to 66°F (2°C to 18°C)
Climate Class	T/ST/N/SN
Protection Class	I
Number of Shelves	5 (adjustable)
Interior Light	Yes, with on/off button
Lock	Yes, key lock on door
Fan	Internal circulating fan
Carbon Filter	Yes, included
Door Material	Glass with seal
Control Panel	Digital display with UP/DOWN and Light buttons
Warranty	1 year limited manufacturer warranty
Cleaning Interval	Condenser cleaning every 6 months
Installation Requirement	Allow 2 hours upright before plug-in; level surface
Safety Compliance	Electrical grounding required; child entrapment prevention

Frequently Asked Questions - NBC177BS00 NewAir

What is the temperature range of the NewAir NBC177BS00 beverage cooler?

The temperature range is from 36°F to 66°F (2°C to 18°C), adjustable in 1-degree increments.

How do I set the temperature?

Press the UP or DOWN button on the control panel to adjust the temperature. The digital display shows the current setting.

Can I turn off the interior light?

Yes, press the Light button on the control panel to toggle the interior light on or off.

How often should I clean the condenser?

Clean the condenser every 6 months to ensure proper operation and avoid malfunction.

What should I do if the cooler is not cooling enough?

Check if the temperature setting is too high, the door is closed properly, the door seal is intact, the front grille is unobstructed, and the cooler is not opened too frequently. Lower the temperature setting if needed.

Why is my cooler making a lot of noise?

Noise may be due to the unit not being level or the fan being obstructed. Ensure the cooler is on a level surface and check the fan for debris.

How do I lock the door?

Use the key to lock the door. Insert the key into the lock located near the handle and turn to lock or unlock.

The door will not close properly. What can I do?

Ensure the unit is level and the door hinges are properly installed. Also check if the shelves are positioned correctly and the door seal is not weak.

Can I use an extension cord?

No, never use an extension cord to connect the cooler to power. Plug it directly into a grounded outlet.

What is the warranty coverage?

The cooler comes with a 1-year limited manufacturer warranty covering defects in materials and workmanship. It does not cover damage from improper use or accidents.

USER MANUAL NBC177BS00 NewAir

177-Can Beverage Cooler

Black and white photo of a modern beverage refrigerator with glass doors filled with Coca-Cola cans (no visible text or labels)

READ AND SAVE THESE INSTRUCTIONS.

TABLE OF CONTENTS

Register Your Product....3

Safety Information & Warnings....4

Parts List 5

Installation....6

Operating Instructions....7

Cleaning & Maintenance 8

Troubleshooting....9

Limited Manufacturer's Warranty....11

SPECIFICATIONS

MODEL NO.	NBC177BS00
VOLTAGE:	110-120V
CURRENT:	1.2A
FREQUENCY:	60Hz
POWER CONSUMPTION:	90W
STORAGE CAPACITY:	5.3 cubic feet
TEMPERATURE RANGE:	36°F - 66°F
PROTECTION CLASS:	I
CLIMATE CLASS:	T/ST/N/SN
PRODUCT WEIGHT:	104 lbs
SHIPPING WEIGHT:	113 lbs
UNIT DIMENSIONS (W X D X H):	23.4" x 22.4" x 33.0"

REGISTER YOUR PRODUCT ONLINE

Register Your NewAir Product Online Today!

Take advantage of all the benefits product registration has to offer:

Service and Support

Diagnose troubleshooting and service issues faster and more accurately

Recall Notifications

Stay up to date for safety, system updates and recall notifications

Special Promotions

Opt-in for NewAir promotions and offers

Registering your product information online is safe & secure and takes less than 2 minutes to complete:

newair.com/register

Alternatively, we recommend you attach a copy of your sales receipt below and record the following information, located on the manufacturer's nameplate on the rear of the unit. You will need this information if it becomes necessary to contact the manufacturer for service inquiries.

Date of Purchase:

Serial Number:

Model Number:

SAFETY INFORMATION & WARNINGS

Warning symbol with exclamation mark inside a triangle (no text or numbers)

When using any electrical appliance, basic safety precautions must be followed in order to reduce the risk of fire, electrical shock and/or injury to persons or property. Be sure to read all instructions before using this appliance and observe the following safety tips:

Attention: To avoid the risk of child entrapment, do not allow children to operate, play with, or crawl inside the unit. If the unit will not be used for an extended period of time, remove the door and leave the shelves in place so that children cannot crawl inside. Also remove the door when disposing of the unit.

Shock Hazard – Electrical Grounding Required

• Never attempt to repair or perform maintenance on the unit until the electricity has been disconnected.
• Never remove the round grounding prong from the plug and never use a two-prong grounding adaptor.
• Altering or cutting of power cord, removal of power cord, removal of power plug, or direct wiring can cause serious injury, fire, and loss of property and/or life, and will void the warranty.
• Never use an extension cord to connect power to the unit.
• Avoid operating this cooler in excessively moist or humid environments.

Important Precautions:

• Do not lift unit by door handle.
• Never install or operate the unit behind closed doors.
• Be sure the kick-plate on the front bottom is free of obstruction. Obstructing airflow can caused the unit to malfunction and will void the warranty.
• Failure to clean the condenser every six months can cause the unit to malfunction.
• Allow unit temperature to stabilize for 24 hours before use.
• Do not block any internal fans.
• Keep the cooler away from hazardous materials or combustible/flammable substances.
• Use only genuine supplier's replacement parts. Imitation parts can damage the unit, affect its operation or performance, and may void the warranty.

PARTS LIST

1、Right upper Hinge
2、Light switch
3、Temperature setting
4、Temperature display
5、Temperature setting
6、Temperature setting
7、Carbon filter

8、Light
9、Fan
10、NTC point
11、Exhaust window
12、Shelf
13、Exhaust window
14、Foot

15、Glass
16、Door seal
17、Handle
18、Lower Hinge
19、Lock

INSTALLATION

Before connecting the appliance to a power source, let it stand upright for approximately 2 hours. This will reduce the possibility of a malfunction in the cooling system from handling during transportation.

Before operating your cooler for the first time, follow these steps:

• Remove the exterior and interior packing.
• Clean the interior surface of the unit with lukewarm water and a soft cloth.
• Place the cooler on a level surface that will be strong enough to support the unit when it is fully loaded. To level your cooler, adjust the front feet located at the bottom of the unit.

OPERATING INSTRUCTIONS

HOW TO USE THE BUTTONS ON THE DISPLAY PANEL

Raise the desired temperature. *

Lower the desired temperature. *

* To set the temperature, press the UP or DOWN button on the control panel. The interior temperature can be adjusted in increments of 1 degree between 36°F and 66°F (2° - 18°C).

The interior light can be turned on or off by pressing the "Light" button.

ADDITIONAL NOTES

• The appliance should not be used by children or persons with reduced physical, sensory or mental capabilities, or lack of experience.
• Children should not play with the appliance. Cleaning and user maintenance should be performed under adult supervision.
• If the supply cord is damaged, it must be replaced by the manufacturer, its service agent, or similarly qualified persons in order to avoid a safety hazard.
• Keep ventilation openings, in the appliance enclosure or in the built-in structure, clear of obstruction.
• Do not use mechanical devices or means other than those recommended by the manufacturer to accelerate the defrosting process.
• Do not damage the refrigerant circuit.
• Do not use electrical appliances other than those recommended by the manufacturer inside the storage compartments of the appliance.
• Do not store explosive substances such as aerosol cans with a flammable propellant in the appliance.
• This appliance is intended for use only in the household, office and similar environments.

CLEANING & MAINTENANCE

CLEANING YOUR COOLER

To clean your cooler:

• Unplug the cooler and remove anything inside.
- Wash the inside of the unit with a solution made of warm water and baking soda solution (2 tablespoons of baking soda to one quart of water).
- Unscrew the water reservoir at the bottom of the unit and rinse with water.
• To clean the outside of the unit, use a mild detergent and warm water.

MOVING YOUR COOLER

To move your cooler:

• Remove anything stored inside.
• Securely tape down all loose parts located inside the unit.
• Turn the leveling feet up to the base in order to avoid damage.
• Tape the door shut.
• Be sure the cooler stays in an upright position during transportation.

TROUBLESHOOTING

Problem	Possible Causes	Solution
Cooler does not operate.	The unit may be plugged in using a different voltage.	Check if using the wrong voltage.
	The circuit breaker may be tripped or there is a blown fuse.	Reset the circuit breaker or check for a broken fuse
Cooler is not cold enough.	The external environment may require a higher setting.	Lower the temperature of the cooler.
	The door may be opened too frequently.	Open the door less frequently.
	The door is not closed completely.	Make sure the door is closed securely.
	The door seal does not seal properly.	Replace the seal on the door. Replacements can be acquired from the manufacturer.
	The front grille is obstructed.	Make sure nothing is blocking the front grille.
The light does not work.	There may be a problem with the display board.	Contact the manufacturer.
The cooler vibrates while operating.	The unit is not sitting on a level floor, or the unit's feet are not correctly installed.	Make sure the unit's feet are in the proper position and tightened securely.
The cooler produces a lot of noise.	The unit is not leveled.	See above.
	The fan may be obstructed	Check the fan to make sure there is no debris or obstruction. If not, contact the manufacturer.
The door will not close properly.	The unit is not leveled.The door is not properly installed.	See above.Check the door hinges to make sure they are properly installed.
	The seal is weak.	Replace the seal on the door. Replacements can be acquired from the manufacturer.
	The shelves are out of position.	Make sure the shelves slide all the way into the unit.
The LED display does not work.	There may be a problem with the main control board.	Contact the manufacturer.
	There is a problem with the plug.	Contact the manufacturer.
There is an LED display error, or the LED displays “LO”.	The cooling kit is no longer working properly.	Contact the manufacturer.
	The PC Board is faulty.	Contact the manufacturer.
The buttons do not function.	The temperature control panel may be damaged.	Contact the manufacturer.

LIMITED MANUFACTURER'S WARRANTY

This appliance is covered by a limited manufacturer's warranty. For one year from the original date of purchase, the manufacturer will repair or replace any parts of this appliance that prove to be defective in materials and workmanship, provided the appliance has been used under normal operating conditions as intended by the manufacturer.

Warranty Terms:

During the first year, any components of this appliance found to be defective due to materials or workmanship will be repaired or replaced, at the manufacturer's discretion, at no charge to the original purchaser. The purchaser will be responsible for any removal or transportation costs, if needed.

Warranty Exclusions:

The warranty will not apply if damage is caused by any of the following:

• Power failure
  • Damage in transit or when moving the appliance
• Improper power supply such as low voltage, defective household wiring or inadequate fuses
• Accident, alteration, misuse or abuse of the appliance such as using non-approved accessories, inadequate air circulation in the room or abnormal operating conditions (extreme temperatures)
  • Use in commercial or industrial applications
• Fire, water damage, theft, war, riot, hostility or acts of God such as hurricanes, floods, etc.
  • Use of force or damage caused by external influences
  • Partially or completely dismantled appliances
• Excess wear and tear by the user

Replacement parts and/or units will be new, re-manufactured or refurbished and is subject to the manufacturer's discretion. For technical support and warranty service, please email [e-mail]