CLP-180 - Security Camera CRUX - Free user manual and instructions

USER MANUAL CLP-180 CRUX

• 180 degree viewing angle
• 720p AHD chipset for a clearer image
• Low light sensitivity
• With optional parking guide lines
• Includes a license plate and butterfly mount for mounting flexibility

Exterior view of a modern office building (no signage)

PARTS INCLUDED:

CLP-180 CAMERA EXTENSION CABLE Butterfly Mount

INSTALLATION DIAGRAM:

graph LR
    A["Reverse Camera Interface Backup Camera Input"] --> B["To Aftermarket Radio Backup Camera Input"]
    B --> C["Extension Coax Cable"]
    C --> D["Regulator"]
    D --> E["Make sure the arrows line up and push in the connectors well."]
    E --> F["License Plate Camera"]
    F --> G["WHITE Wire Parking Guideline Cut = ON Joined = OFF"]
    H["RED Wire (A)*"] --> D
    I["RED Wire (B)*"] --> D
    J["GROUND"] --> D

*NOTE: The camera needs a +12V trigger. Power the camera at the headunit using RED Wire B or from the reverse light wire using RED Wire A. DO NOT connect both wires to +12V at the same time. Insulate the red wire that is not being used. Tap the Black wire to an existing ground lead, or ground Black wire securely to vehicle body metal.

LICENSE PLATE CAMERA INSTALLATION:

1. Remove the license plate. 2. The license plate bar is mounted behind the license plate.

Close-up of hands installing or adjusting a car door panel with cables (no visible text or symbols)

1. Adjust the angle if necessary.