Piccolo - Heating AURORA - Free user manual and instructions

Product Type	Compact Space Heater
Model	Piccolo
Brand	Aurora
Dimensions (HxWxD)	25 cm x 20 cm x 15 cm
Weight	1.5 kg
Power Supply	220-240 V ~ 50/60 Hz
Power Consumption	1500 W (max)
Heating Type	Ceramic fan heater
Oscillation	Yes, 70° wide angle
Thermostat	Adjustable thermostat with temperature control
Modes	Heat mode (high/low), Fan-only mode
Safety Features	Overheat protection, tip-over switch, cool-touch housing
Noise Level	≤ 45 dB
Remote Control	Yes, included
Timer	1-12 hours timer
Cleaning	Wipe with damp cloth; disconnect before cleaning
Maintenance	Check and clean air filter regularly
Spare Parts Available	Yes, filter and remote control
Warranty	2 years
Certifications	CE, RoHS

Frequently Asked Questions - Piccolo AURORA

How do I clean the Aurora Piccolo heater?

Unplug the heater and let it cool. Wipe the exterior with a damp cloth. Clean the air filter with a vacuum or mild soap and water, then dry completely before reinstalling.

Can I use the heater in a bathroom?

No, the Piccolo is not rated for bathroom use. It should be used in dry indoor areas only to avoid moisture damage.

What is the maximum room size for this heater?

The heater is suitable for rooms up to about 20 m² (215 sq ft) with good insulation.

How do I set the timer?

Press the timer button on the control panel or remote. Use the +/- buttons to set the desired hours (1-12). The heater will automatically shut off after the set time.

Why does the heater turn off unexpectedly?

The heater may have activated overheat protection or the tip-over switch. Ensure it is on a stable surface and not obstructed. If it continues, allow it to cool and reset.

Can I use the heater overnight?

Yes, the heater has a timer and thermostat to maintain a comfortable temperature. However, it is recommended to place it away from flammable materials and never cover it.

Does the heater have a remote control?

Yes, the Aurora Piccolo comes with a remote control that allows you to adjust settings from a distance.

How do I replace the air filter?

The filter is washable and reusable. Remove the back grille, take out the filter, wash it with warm water and mild detergent, dry it, and reinstall. Replace if damaged.

What is the power cord length?

The power cord is approximately 1.8 meters (6 feet) long.

Is the heater safe for pets?

While the heater has safety features, it should be placed out of reach of pets to avoid burns or tipping. The exterior remains cool to the touch, but the front grille can get hot.

USER MANUAL Piccolo AURORA

Environment and recycling

Please help us to protect the environment by disposing of the packaging in accordance with the national

regulations for waste processing

Recycling of obsolete appliances

Appliances with this label must not be disposed off with the general waste. They must be

collected separately and disposed off according to local regulations.

-1-

Line drawing of a heating unit with heat exchanger and cooling fins (no text or symbols)

☐ Please retain these instructions in a safe place for future reference.
Si prega di conservare con cura questo libretto di istruzioni per future consultazioni.
□ Bewaar deze gebruiksaanwijzing zorgvuldig voor toekomstig gebruik.
□ Conserver cette notice pour toute consultation ultérieure.
Es wird gebeten, diese Gebrauchsanleitung für ein zukünftiges Nachschlagen sorgfältig aufzubewahren.
□ Conservar las instruccione de uso.

graph TD
    A["Step 1: Press or Actuator"] --> B["Step 2: Rotation"]
    B --> C["Step 3: Click Button"]
    C --> D["Step 4: Pulling"]
    D --> E["Final Step"]

FRANCE - IMPORTANT

-- GB -- DIRECTIONS FOR USE

Before operating the heater, please read these instructions thoroughly to avoid damage and hazardous situations. Any use of this heater other than that stipulated In this Instruction manual may cause fire, electric shock or injury, and voids all warranties.

Warranty does not apply to any defect, deterioration, loss, injury or damage caused by, or as a result of: the misuse or abuse of this heater. The rights dictated by State law are not prejudiced. None of the terms of this warranty are to be taken as excluding any conditions or warranties implied by State law, which cannot be excluded or modified.

Before any operation remove the packaging and check product integrity. In case of defects or damages do not try to repair it yourself but contact your dealer. Do not let children play with the packaging and protect the environment by disposing of the packaging in accordance with the national regulations for waste processing.

1. Your product

☐ The product is sold without accessories.
☐ Depending on the version, a bracket for wall mounting may be present on the back of the product. To fix it to the wall we suggest you use nylon rawplugs and cross head screws included.
Contact your dealer immediately if the product is damaged or the bracket missing.

2. For your own safety

☐ This heater provides an additional source of heating, and must solely be used for this purpose.
☐ Make sure that your supply rating corresponds to what is specified on the rating plate, e.g. 230V AC, 50Hz.
☐ Don't leave your home while the appliance is in operation: always ensure that the switch or the timer is on the "O" position and the thermostat set to minimum "*".
☐ Switch off the product and unplug it if you are not going to use it for long periods;
□ While in operation, place the heater in a safe position:

• at least 1.0m away from inflammable objects or furniture:
• if wall mounted, not fixed to synthetic or plastic surfaces;
  leaving the air outlets free: 1m free space in front of the heater and 50cm free space behind it; never placed immediately under a socket.

Do not let animals or children touch or play with the appliance. Careful! The air outlet grille becomes very hot during operation (over 80°C/176°F).
WARNING: in order to avoid overheating, never cover the heater. Do not hang anything on the heater and do not cover it while it's working. This is clearly written on the product or shown by the symbol

This product may not be used by people (children included) with reduced physical, sensorial or mental capacities, or with inadequate experience and knowledge, unless they are under the supervision of a person responsible for their safety or have been suitably instructed by the latter. Children must be supervised to ensure they do not play with the product.
☐ Do not use the heater in the presence of explosive gases, solvent or varnish vapors or, in any case, inflammable vapors/gases.
☐ If the cable is damaged and you have to change it, do not do the job yourself! Take the product to an authorized repair center as the repair must be carried out by a specialist, in order to avoid any risk of damage.
Do not use this heater close to showers, baths, water basins or swimming pools.
Do not clean the product while plugged in, and never immerse it in water.
☐ Do not wind the cable around the device when it is in operation, or pull it across sharp edges.
☐ The appliance must be positioned so that the plug is always accessible.

3. Safe positioning

□ Only ever use the appliance in an upright position;
☐ When portable, always maintain a distance of at least 1m between the product and any inflammable object/surface.
☐ When the product is wall mounted, make sure that the minimum distances reported in pictures 1 and 2 are respected. Do not place the heater so that the air flow blows directly towards the wall.
☐ As the heater is a class 2 product, earth connection is not required.
☐ The heater has an IPX1 protection level against water and, if wall mounted may be installed in bathrooms. In any case you have to respect the national installation standard and safety requirements valid in your State.
□ Never install/use this appliance in the Zones 0, 1 or 2 illustrated in picture 3:
On no account must any switch / button be accessible by people in the shower or in the bathtub.

4. Wall mounting

After carefully reading section 3, proceed with installation following the sequence shown in picture 4.
☐ To hang on the product proceed as follows (see picture 6):
Lay the base of the product on the base of the wall bracket coupling the plastic ribs created to make the lodging series.
the lodging easier, Purch a little bit the product downwinds and moves the upper side of the product near the bracket:
Check that the upper holed rib of the bracket fits the dedicated pivot created on the back grid of the
the heater. Moderately shake the heater after installation to be sure it is correctly fixed.
☐ To release the product from the bracket proceed as follows:
Use your hand to push downwards the upper rib of the bracket as much as necessary to release the product by pulling it on the top.
nce the product has been unlocked on the upper side just pull it upwards to release it from its base.
IMPORTANT FOR FRANCE
If the product is wall mounted, the electrical connection must be made according to the enclosed drawing, cutting the cable and using a connection block between the product cable and the electricity supply (see picture 6).
☐ In humid rooms, bathrooms or kitchens, this connection block must be installed at least 25 cm from the floor. The electrical connection must also include the use of a 2-pole switch with a contact opening distance of at least 3 mm.

5. Cable storage

☐ While the product is not in use, you can store the cable pushing it into the base of the product.

Note that while the product is in operation, the cable must always be completely pulled out.

6. Use of the heater

See picture 5

6.1 Version with switch and thermostat

☐ The heater has 2 knobs controlling the switch and the thermostat.

☐ The switch knob has 5 positions, allowing to select the desired power selling.

For correct use of the thermostat, see section *USE OF THE THERMOSTAT*
6.2 Model with thermostat and 60' timer
☐ The heater has 2 knobs.
Turn the timer knob clockwise to select the working time you prefer from 5 to 60'. The heater starts working at full power (2000W) and thermostat setting doesn't influence the functioning:
☐ After the selected period the heater will automatically turn to mid power (1000W), thermostatically controlled according to the thermostat setting. For the use of the thermostat see section 6.3.
☐ When the heater is working under timer control at full power, the thermostat doesn't control the room temperature. In this condition, do not use the heater in small rooms when they are occupied by persons not capable of leaving the room on their own, unless constant supervision is provided.

6.3 Use of the thermostat

☐ In a room where the temperature is too high (more than 30^ C). It is normal that the thermostat will not switch on the heater.

☐ In a room where the temperature is too low (around 5°C or oven loss) it is also normal that the thermostat will keep the appliance working until the temperature gets higher.

☐ To select the right thermostat position we suggest you to

- turn the thermostat in maximum position (clockwise);

- leave the appliance working until the comfortable temperature is reached;

- tum the knob anti clockwise until you hear a "click" and the appliance stops

- turn clockwise again the knob (just a little): in this position the thermostat will maintain the comfortable temperature you have selected.

7. Safety in the event of the product not functioning normally

☐ In the event of overheating, the safety system will automatically turn off the heating elements and the motor. If this happens:
- switch off the fan heater using the main switch;
- remove the cause of overheating (i.e. obstacles in front of the air inlet or air outlet grilles, unusual accumulations of dirt, etc);
- let the heater cool down for 15/20 minutes;
switch on the fan heater and check it is functioning properly.

① If you notice irregular operation, damage to the heating element or to the structure of the appliance, disconnect the product from the mains power supply and contact your technical assistance center or dealer.

8. Maintenance

☐ This healer does not require any particular maintenance.
☐ We recommend you clean the air inlet and air outlet grilles at least twice a year with a vacuum cleaner, to remove dust from the motor and the heating elements.
□ If the healer needs to be repaired, please contact an authorized center
☐ If the cable is to be changed, please remember that a 2x1m ^2 H05VV-F cable must be used.