HDGE90H - Tumble drier HISENSE - Free user manual and instructions
Find the device manual for free HDGE90H HISENSE in PDF.
Pick your language and provide your email: we'll send you a specifically translated version.
| Brand | Hisense |
| Model | HDGE90H |
| Product Type | Tumble Dryer |
| Drying Capacity | 9 kg |
| Energy Efficiency Class | A++ |
| Annual Energy Consumption | 561 kWh |
| Dimensions (H x W x D) | 850 x 595 x 580 mm |
| Weight | 50 kg |
| Voltage / Frequency | 220-240 V / 50 Hz |
| Power Consumption (Off Mode) | 0.5 W |
| Drying Technology | Condenser (Heat Pump) |
| Number of Programs | 15 |
| Key Programs | Cotton, Synthetics, Delicates, Wool, Timed Drying, Anti-Allergy |
| Features | Sensor Drying, Anti-Crease, Delay Start, Child Lock |
| Drum Volume | 118 L |
| Filter Type | Lint Filter + Condenser Filter |
| Water Tank Capacity | 4.5 L |
| Reversible Door | Yes |
| Noise Level | 65 dB(A) |
| Warranty | 2 Years |
Frequently Asked Questions - HDGE90H HISENSE
How do I clean the lint filter on my Hisense HDGE90H?
Open the door, pull out the lint filter from the bottom of the door opening, remove lint by hand or with a soft brush, rinse under running water if necessary, and dry thoroughly before replacing. Clean after each use for optimal performance.
What should I do if the dryer does not start?
Check that the door is fully closed, the plug is inserted securely, and the circuit breaker is on. Also ensure the water tank is not full (if applicable) and the program is selected. Refer to the user manual for error codes.
How often should I clean the condenser unit?
Every 30 drying cycles or when the 'Clean Condenser' indicator lights up. Remove the lower flap, take out the condenser, rinse with water to remove lint, and replace. Ensure it is completely dry before reinserting.
Can I dry wool items in the HDGE90H?
Yes, the dryer has a specific Wool program designed for machine-washable wool. Use a low temperature and do not overfill. Always check the garment care label.
What does the 'Anti-Crease' function do?
After the drying cycle ends, the drum rotates periodically for up to 60 minutes to prevent wrinkles. You can extend or deactivate this function via the control panel.
How do I empty the water tank?
Pull out the water tank drawer located at the bottom left of the dryer, pour the water into a sink, and reinsert the drawer. Ensure it is correctly seated to avoid leaks.
Why is the drying cycle taking too long?
Possible causes include a clogged lint filter or condenser, too large load, high room temperature, or the selected program. Clean filters and reduce load size to improve efficiency.
Can I install the dryer in a cupboard?
Yes, but ensure adequate ventilation. The dryer must be placed on a stable surface with at least 10 cm clearance on all sides for air circulation. Do not block the vents.
How do I activate the child lock?
Press and hold the 'Child Lock' button (usually marked with a padlock icon) for 3 seconds until the indicator appears. To deactivate, repeat the process.
What should I do if the dryer smells?
Clean the lint filter and condenser, inspect for trapped items or lint buildup, and run a 'Drum Clean' cycle if available. Leave the door open between uses to air out.
User questions about HDGE90H HISENSE
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
No questions yet. Be the first to ask one.
Download the instructions for your Tumble drier in PDF format for free! Find your manual HDGE90H - HISENSE and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. HDGE90H by HISENSE.