01418 - Light dimmer Vimar - Free user manual and instructions

Type de produit	Light Dimmer
Modèle	01418
Marque	Vimar
Ligne de produit	By-me Plus
Application	Home automation, lighting control
Tension d'alimentation	230 V AC, 50 Hz
Charge maximale (LED)	300 W
Charge maximale (incandescente)	600 W
Type de contrôle	Push-button or remote via bus
Dimensions (L x H x P)	45 x 45 x 25 mm
Poids	50 g
Montage	DIN rail or flush mounting
Type de borne	Screw terminals
Protection	Overheat, short circuit
Température de fonctionnement	0 °C à 40 °C
Température de stockage	-20 °C à 70 °C
Humidité	10% à 90% sans condensation
Normes	CE, RoHS
Garantie	2 ans
Entretien	Nettoyer avec un chiffon sec
Sécurité	Installation par un électricien qualifié
Pièces détachées	Non disponibles séparément
Fonctions	Variation, marche/arrêt, contrôle de scène

Frequently Asked Questions - 01418 Vimar

How do I install the Vimar 01418 dimmer?

Installation must be performed by a qualified electrician. Ensure power is off, connect to 230V AC supply, and follow the wiring diagram in the manual. The device can be mounted on a DIN rail or flush-mounted.

Is the 01418 compatible with LED bulbs?

Yes, it supports LED loads up to 300W. For best performance, use dimmable LED bulbs and check the minimum load requirement (typically 5W).

What is the minimum load for the dimmer?

The minimum load is approximately 5W for LED bulbs and 40W for incandescent bulbs. Operating below this may cause flickering or improper dimming.

How do I wire the Vimar 01418 dimmer?

Connect the live wire (L) to terminal L, neutral (N) to N, and the load wire to the output terminal. Ensure correct polarity and use screw terminals. Refer to the diagram in the manual.

Why is my light flickering after installation?

Flickering can be caused by incompatible bulbs, insufficient load, or loose wiring. Try using dimmable LEDs with a minimum load, check connections, or reduce the number of bulbs if total load is too low.

Can I use the 01418 with a remote control or smart home system?

Yes, the dimmer is part of the Vimar By-me Plus system and can be controlled via bus with compatible switches, remotes, or home automation gateways.

How do I reset the Vimar 01418 dimmer?

To reset, disconnect power for at least 10 seconds, then reconnect. If issues persist, check the bus communication or consult the manual for a factory reset procedure.

What is the warranty period for the 01418?

Vimar typically offers a 2-year warranty from the date of purchase. Keep proof of purchase for service claims.

Can I pair the dimmer with a push-button switch?

Yes, connect a normally open push-button to the appropriate terminals (e.g., S1/S2). The dimmer supports momentary switches for toggle or dimming control.

How do I dispose of the Vimar 01418 at end of life?

Dispose of the device according to local regulations for electronic waste. Do not dispose in household waste. Recycle through designated collection points.

USER MANUAL 01418 Vimar

. By-me Plus . BY- me. Business Applications Expected by the European Environmental Policy for Environmental Protection.