ManualGo.com CFBD2450 - Fridge CANDY - Free user manual and instructions
Find the device manual for free CFBD2450 CANDY in PDF.
Download the instructions for your Fridge in PDF format for free! Find your manual CFBD2450 - CANDY and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. CFBD2450 by CANDY.
USER MANUAL CFBD2450 CANDY
BUILT-IN DOUBLE DOOR CONTROL PANEL The thermostat box to control the appliance is located inside the fridge compartment on the top right. To check whether the appliance is functioning, make sure that the thermostat knob is not set on "0".
DEFROSTING AND FREEZING The rating plate states the maximum quantity of foods that can be frozen, (see figure 2).
Freezing is guaranteed with any knob setting. Defrosting of the fridge compartment occurs automatically in this product.
We recommend you defrost the freezer area when the layer of frost is more than 3 mm thick.
A small amount of frost or drops of water on the back of the fridge compartment when the fridge is working is normal.
Make sure the water outlet is always clean and make sure foods do not touch the back or sides of the freezer compartment.
N.B. Here you will find your appliance rating plate: it includes all the data to be transmitted to the Customer Service should a fault arise.
Important: if your ambient temperature is high, the appliance may operate continuously, thus building up excessive frost on the inner wall of the fridge. In this case, turn the fridge knob to a warmer setting (1-2).
REVERSING THE OPENING OF THE DOORS Remove the upper hinge and its spacers from the upper crossbeam.
Remove the upper door.
Remove the right lower hinge and refit it on the opposite side.
Reassemble the hinges and doors working from bottom to top 1
Remove the hinge and its spacers.
55EN IT Remove the bottom door.
PRODUCT DIMENSIONS AND BUILT-IN COMPARTMENT INSTALLATION OF THE APPLIANCE IN THE COLUMN Secure the seal (supplied) to the appliance, on the opposite side from the hinges.
Make sure the top connecting plate of the cabinet fits perfectly.
Insert the appliance in the column, placing it on the opposite side of the hinges.
Secure the appliance upper part to the cabinet, using the supplied screws.
Click the ventilation grill.
66EN IT Secure the appliance lower part using the supplied screws.
COUPLING OF THE PANELS OF THE BUILT-IN COLUMN OF THE APPLIANCE DOORS The appliance is equipped with coupling devices for the appliance doors with the column panels (loader slide).
Secure the slide in the inner part of the panel of the built-in column at the desired height and at approx. 20 mm. From the outer wire of the door.
PRECAUTIONS FOR THE CORRECT OPERATION Once the product has been embedded, place the rear part of the column in contact with the wall so as to prevent access to the compressor compartment.
For the product to operate correctly it is essential to allow adequate air circulation so as to cool down the condenser located in the rear part of the appliance. For this reason, the column must be equipped with a rear chimney, whose upper opening must not be blocked and with a front slot which will be covered with a ventilation grill.