H6 3 - SanGiorgio - Free user manual and instructions
Find the device manual for free H6 3 SanGiorgio in PDF.
Pick your language and provide your email: we'll send you a specifically translated version.
| Type of product | Wall-mounted cooker hood |
| Brand | SanGiorgio |
| Model | H6 3 |
| Dimensions (H x W x D) | 150 x 598 x 500 mm |
| Weight | 12 kg |
| Power supply | 220-240 V ~ 50/60 Hz |
| Maximum motor power | 220 W |
| Total power consumption | 260 W |
| Number of speeds | 3 |
| Maximum extraction capacity | 620 m³/h |
| Noise level | 53-67 dB(A) |
| Lighting | 2 x 20 W halogen bulbs |
| Duct outlet diameter | 150 mm |
| Grease filter type | Washable aluminum mesh |
| Charcoal filter optional | Yes, for recirculation mode |
| Controls | Mechanical push buttons |
| Material | Stainless steel |
| Installation | Permanent wired installation |
| Operating modes | Extraction and recirculation |
| Safety features | Thermal overload protection, safety cut-out |
Frequently Asked Questions - H6 3 SanGiorgio
What type of product is the SanGiorgio H6 3?
The SanGiorgio H6 3 is a wall-mounted cooker hood designed for kitchens, with a 620 m³/h extraction capacity and three operating speeds.
How do I install the H6 3 range hood?
Installation must be done by a qualified technician. The hood must be mounted at the recommended height above the hob: 60-75 cm for electric hobs and 75-85 cm for gas hobs. Secure the fixing brackets, connect the ducting to the 150 mm outlet, and complete the electrical connection.
How should I clean the aluminum grease filters?
The grease filters should be cleaned every 2-4 weeks depending on use. Remove them and wash with warm water and mild detergent, or place them in the dishwasher at a low temperature. Reinstall them completely dry.
When should I replace the charcoal filter and where can I find it?
Replace the charcoal filter every 3-6 months, especially in recirculation mode. This filter is not supplied with the hood and must be purchased separately from SanGiorgio spare parts dealers. It cannot be washed or regenerated.
What should I do if the hood is unusually noisy?
If noise increases, check for obstructions in the ducting, clean the grease filters and inspect the fan blades for debris. A persistent rattling sound may indicate a loose mounting bracket; tighten all fixings and contact customer service if needed.
Why is the hood not extracting effectively?
Check whether the grease filters are clogged, the charcoal filter is saturated in recirculation mode, or the ducting is blocked or too long. Make sure the room is well ventilated and that the hood is set to the correct speed for your cooking.
How do I replace the light bulbs in the H6 3?
Switch off the hood and disconnect the power. Remove the lamp cover with a flat screwdriver, replace the 20 W halogen bulb with an identical type, and reinstall the cover before restoring power.
What are the recommended clearances from the hob?
For safe operation, keep a minimum distance of 60 cm from electric hobs and 75 cm from gas hobs. The exact clearance may vary by local regulations; always consult the installation manual.
Is the H6 3 suitable for recirculation mode?
Yes, the H6 3 can be used in recirculation mode by fitting an activated charcoal filter and diverting the air through the top grille. This is useful when no external duct outlet is available.
How do I operate the speed controls?
The control panel features three mechanical push buttons: one for low speed, one for medium speed, and one for high speed. Turn the hood off by pressing the corresponding button again or using the dedicated off button, depending on the model.
User questions about H6 3 SanGiorgio
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
No questions yet. Be the first to ask one.
Download the instructions for your in PDF format for free! Find your manual H6 3 - SanGiorgio and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. H6 3 by SanGiorgio.