Tri-XO Crossover - Water pump ZODIAC - Free user manual and instructions
Find the device manual for free Tri-XO Crossover ZODIAC in PDF.
Pick your language and provide your email: we'll send you a specifically translated version.
| Type of product | Swimming pool water pump |
| Brand | ZODIAC |
| Model | Tri-XO Crossover |
| Intended use | Circulation and filtration of pool water |
| Power supply | 230 V ~ 50 Hz |
| Power consumption | 350 W |
| Max. flow rate | 10,000 L/h |
| Max. head | 8 m |
| Inlet diameter | 1.5-in (38 mm) |
| Outlet diameter | 1.5-in (38 mm) |
| Pre-filter | Built-in basket with 180 μm mesh |
| Housing material | Durable thermoplastic |
| Motor type | Single-phase asynchronous motor |
| Thermal protection | Built-in overload protector |
| Noise level | Approx. 58 dB(A) |
| Operating temperature | 4 °C to 40 °C |
| Dimensions (W x D x H) | 310 x 210 x 350 mm |
| Weight | 6.8 kg |
| Ingress protection | IPX4 |
| Cable length | 2.5 m |
| Maintenance | Easy access strainer basket and impeller |
| Safety | Class I insulation |
| Certifications | CE compliant |
| Repairability | Replaceable parts available (impeller, shaft seal, basket) |
Frequently Asked Questions - Tri-XO Crossover ZODIAC
How do I install the Tri-XO Crossover water pump?
Installation is straightforward. Place the pump on a flat, stable surface below the pool water level. Connect the inlet and outlet pipes using the 1.5-in (38 mm) unions. Ensure all connections are tight and secure. Prime the pump by filling the pre-filter basket with water before starting. Then plug into a grounded socket and switch on.
What type of pool is this pump suitable for?
The Tri-XO Crossover is designed for above-ground pools and small inground pools with a volume up to 30 m³. It is compatible with standard pool filtration systems and can be used for water circulation, vacuuming, and emptying operations.
How do I clean the pre-filter basket?
Turn off the pump and disconnect power. Unlock the transparent lid by turning it counterclockwise. Lift the pre-filter basket out, rinse it with clean water, and remove any debris. Check the strainer for damage. Reinstall the basket, close the lid, and tighten it securely.
The pump is making an unusual noise. What could be the cause?
Noise is often caused by cavitation or debris blocking the impeller. Check the pre-filter basket for obstructions. Make sure the pump is not running dry. Air in the system can also cause noise – bleed the air by slightly loosening the outlet union until water flows consistently, then tighten again.
What should I do if the pump loses its prime?
If the pump runs but does not draw water, stop the pump immediately. Remove the lid and fill the pre-filter basket with water until it is full. Reinstall the lid tightly. Ensure both suction and return lines are free of air locks and that the valve is open. Restart the pump.
How often should I clean the strainer basket?
At the beginning of the season, check the basket daily, especially during heavy use. In normal conditions, clean the strainer basket once a week to maintain maximum flow and reduce stress on the pump motor.
Can this pump run without water?
No. Running the pump dry can damage the mechanical seal and motor. Always ensure the pump is properly primed and filled with water before starting. Do not operate it to vacuum the pool if the water level is too low.
Does the pump have thermal overload protection?
Yes, the pump is equipped with a thermal overload protector that automatically shuts off the motor if it overheats. Once the motor cools down, the protector resets. If the pump stops unexpectedly, check the housing for overheating and the cause of the overload.
How should I store the pump during winter?
Drain all water from the pump and pipes. Remove the pre-filter basket and clean it. Disconnect the pump from the electrical supply and store it in a dry, frost-free location. Cover the pump with a cloth to protect it from dust.
Is the pump suitable for saltwater pools?
Yes, the thermoplastic housing and corrosion-resistant components allow the pump to be used with saltwater chlorine generators. However, regular inspection of the mechanical seal and fasteners is recommended to ensure long-term durability.
User questions about Tri-XO Crossover ZODIAC
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
No questions yet. Be the first to ask one.
Download the instructions for your Water pump in PDF format for free! Find your manual Tri-XO Crossover - ZODIAC and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. Tri-XO Crossover by ZODIAC.
USER MANUAL Tri-XO Crossover ZODIAC
Manual assistant
Powered by Anthropic
Waiting for your message
Product information
Brand : ZODIAC
Model : Tri-XO Crossover
Category : Water pump