QVW-173 - Monitor MARSHALL - Free user manual and instructions

To connect via HDMI, use a standard HDMI cable. Plug one end into your computer's HDMI output and the other into the HDMI input on the monitor. Then press the Input button on the monitor to select HDMI as the active source. Your computer should automatically detect the monitor and extend or mirror the display.

Press the Input button on the monitor's bottom bezel or on the remote control to cycle through available sources. The options include HDMI, DisplayPort, VGA, and Composite. The current source is displayed in the on-screen display (OSD).

On your computer, go to the display settings (e.g., Windows Display Settings or macOS Displays). Select the recommended resolution, which is 1920 x 1080 for the QVW-173. If the correct resolution is not listed, update your graphics card driver to ensure all available modes are recognized.

Yes, the monitor supports the standard 100 x 100 mm VESA mounting. Use a compatible VESA arm or wall bracket. Remove the stand (if attached) by pressing the release button and sliding it off. Then attach the mounting plate to the back of the monitor using M4 screws of appropriate length.

Turn off the monitor and unplug it for safety. Use a soft, lint-free dry cloth (like a microfiber cloth) to gently wipe the screen. For stubborn smudges, dampen the cloth slightly with water or a screen-safe cleaner. Avoid using paper towels, abrasive pads, or strong chemicals, as they can damage the anti-glare coating.

If the screen shows 'No Signal', first check that the power cable is connected and the monitor is turned on. Then verify that the video cable (HDMI, DisplayPort, VGA, or Composite) is securely plugged into both the monitor and the source device. Press the Input button to cycle to the correct source. If using a laptop, make sure it is not in sleep mode and that the external display is enabled (e.g., Windows key + P to select 'Extend' or 'Duplicate').

The QVW-173 supports HDR when connected via HDMI or DisplayPort. To enable HDR, open the on-screen display (OSD) menu by pressing the Menu button. Navigate to Picture > HDR and select On. Ensure your source device is also outputting an HDR signal, and that the graphics card or video player is configured accordingly.

Press the Menu button on the monitor to open the OSD. Use the arrow keys to navigate to Picture settings. Select Brightness or Contrast and adjust using the +/- buttons. The changes are saved automatically. You can also switch between predefined picture modes (Standard, Movie, Game, etc.) for optimal settings.

To reset all monitor settings, open the OSD menu, go to Settings (or Setup), and choose Reset or Factory Reset. Confirm the selection by pressing OK. This will restore the default picture, color, and OSD settings, but will not erase any saved input source preferences.

Yes, the QVW-173 works with Mac computers via HDMI or DisplayPort. Connect the Mac's Thunderbolt/USB-C port to the monitor using an appropriate adapter or cable. On macOS, go to System Preferences > Displays to adjust resolution and mirroring. Note that VGA input may require a separate adapter, and some Mac models may need an active adapter for optimal output.