MOB02-18HFRN8 - Air conditioner MIDEA - Free user manual and instructions
Find the device manual for free MOB02-18HFRN8 MIDEA in PDF.
Pick your language and provide your email: we'll send you a specifically translated version.
| Product Type | Portable air conditioner with cooling, heating, fan, and dehumidifier modes |
| Brand | Midea |
| Model Number | MOB02-18HFRN8 |
| Cooling Capacity | 18,000 BTU/hour |
| Heating Capacity | 18,000 BTU/hour (heat pump) |
| Dehumidification Capacity | 40 pints/day |
| Fan Speeds | 3 (High, Medium, Low) |
| Remote Control | Yes, full-function infrared remote included |
| Timer | 24-hour programmable on/off timer |
| Power Supply | 220-240 V, 50 Hz, single-phase |
| Power Consumption | 2100 W (cooling), 2000 W (heating) |
| Airflow Volume | Up to 320 m³/h |
| Noise Level | ≤ 65 dB(A) on high speed |
| Dimensions (W × D × H) | 64.5 cm × 45.0 cm × 91.0 cm |
| Weight | 40 kg |
| Refrigerant | R32 |
| Installation | Portable unit with window exhaust kit, no permanent installation required |
| Maintenance | Washable air filter, drain hose, and removable vent grille; clean filter every 2 weeks |
| Spare Parts & Repairability | Replaceable filters, remote, exhaust hose, and window kit available |
| Safety Features | Overheat protection, automatic restart after power failure, tip-over switch |
Frequently Asked Questions - MOB02-18HFRN8 MIDEA
How do I install the portable air conditioner?
Position the unit near a window, connect the exhaust hose to the back of the unit, attach the window adapter to the hose and secure it in the open window. Plug the air conditioner into a grounded outlet and press the power button. Make sure the hose has no sharp bends to maintain efficient airflow.
How often should I clean the air filter and how?
Clean the washable air filter every two weeks or when the “FL” (filter) indicator lights up. Remove the filter from the back panel, rinse it under lukewarm water or vacuum it, allow it to dry completely, and slide it back into place. A clean filter improves energy efficiency and air quality.
Can I use the air conditioner in fan mode without the exhaust hose?
Yes, in fan-only mode the exhaust hose is not required. However, for cooling and heating modes, the hose must be connected to the window kit to vent exhaust air. Operating the AC without the hose can overheat the compressor and cause error codes.
What is the recommended room size for this air conditioner?
This 18,000 BTU unit is suitable for rooms up to 450 sq ft or about 42 m². For best results, ensure the room is well-sealed and shaded during the hottest part of the day.
How do I drain water from the unit?
In cooling mode most water is evaporated, but in very humid conditions or during heating, water will collect in the internal tank. When the water full indicator lights up, turn off the unit, remove the lower drain plug, and let the water flow into a tray or connect a drain hose for continuous drainage.
Does this model provide heating as well as cooling?
Yes, the MOB02-18HFRN8 is a heat pump air conditioner. It can reverse the cooling cycle to deliver warm air, making it a year-round climate solution. Use the mode button to select heat mode.
What do the error codes E1, E2, and E4 mean?
E1 indicates a faulty room temperature sensor, E2 indicates a broken evaporator coil sensor, and E4 is a floor sensor error. In most cases, unplugging the unit for 10 minutes and plugging it back in resets the system. If the code persists, contact Midea technical support.
How do I set the on/off timer?
Using the remote control, press the TIMER button. Press ▲/▼ to set the desired operating hours (1 to 24). The timer can be set when the unit is on (auto-off) or when off (auto-on). The indicator light confirms the timer is active.
Does the remote control require batteries?
Yes, the remote control comes with two AAA batteries included. If the remote stops working, replace the batteries with fresh ones and check for any obstructions between the remote and the sensor on the unit.
How do I reset the filter reminder light?
After cleaning the air filter, press and hold the - minus button on the control panel for 2 seconds to clear the filter reminder. The “FL” icon will disappear from the display. If the light remains, cycle the power off and on.
User questions about MOB02-18HFRN8 MIDEA
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
No questions yet. Be the first to ask one.
Download the instructions for your Air conditioner in PDF format for free! Find your manual MOB02-18HFRN8 - MIDEA and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. MOB02-18HFRN8 by MIDEA.
USER MANUAL MOB02-18HFRN8 MIDEA
Manual assistant
Powered by Anthropic
Waiting for your message
Product information
Brand : MIDEA
Model : MOB02-18HFRN8
Category : Air conditioner