381094-19 - Uncategorized PIONEER - Free user manual and instructions
Find the device manual for free 381094-19 PIONEER in PDF.
Pick your language and provide your email: we'll send you a specifically translated version.
| Brand | Pioneer |
| Model | 381094-19 |
| Product Type | Stereo Receiver |
| Audio Output Power | 100 W + 100 W (RMS) |
| Total Harmonic Distortion | 0.05% |
| Frequency Response | 10 Hz – 50 kHz |
| Signal-to-Noise Ratio | 90 dB |
| Supported Radio Bands | FM, AM |
| Number of Audio Inputs | 4 (RCA line-level) |
| Number of Speaker Outputs | 2 pairs |
| Headphone Jack | Yes (6.3 mm) |
| Tone Control | Bass, Treble, Balance |
| Display | Fluorescent display |
| Remote Control | Included (batteries not included) |
| Power Supply | AC 120 V, 60 Hz |
| Power Consumption | 120 W (max) |
| Standby Power Consumption | 0.5 W |
| Dimensions (W x H x D) | 435 x 138 x 365 mm |
| Weight | 7.8 kg |
| Operating Temperature | 5 °C to 35 °C |
| Maintenance | Clean the casing with a soft, dry cloth |
| Safety Warning | Do not remove the cover; no user-serviceable parts inside |
| Spare Parts & Reparability | Contact an authorized Pioneer service center for any repairs |
| General Information | For outdoor use: avoid exposure to rain or moisture |
Frequently Asked Questions - 381094-19 PIONEER
How do I connect my speakers to the Pioneer 381094-19?
Connect the speaker wires to the speaker terminals on the back panel, ensuring positive to positive and negative to negative. Use the corresponding channels (e.g., Front Left/Right) for a stereo setup.
How can I preset radio stations on this receiver?
Tune to the desired station manually, then press and hold the preset button (e.g., 1-5) until the display flashes. Repeat for other presets. You can store up to 30 FM and 15 AM stations.
What should I do if there is no sound from my speakers?
Check that the speaker wires are securely connected and the speaker selector on the front panel is set to the correct output. Also verify the volume is not at minimum and the mute function is off.
How do I clean the front panel and casing?
Use a soft, dry cloth to gently wipe the front panel and casing. Do not use chemical solvents or abrasive cleaners, as they may damage the finish.
Can I connect my television to this receiver?
Yes, if your TV has analog audio outputs (RCA), connect them to any available line-level input on the receiver. Then select that input on the receiver.
How do I reset the receiver to factory settings?
With the unit on, press and hold the Preset + and Preset - buttons simultaneously for 5 seconds. This restores factory default settings.
Does the receiver support wireless Bluetooth audio streaming?
No, this model does not have built-in Bluetooth. You can use an external Bluetooth adapter plugged into an available RCA input to stream audio.
What type of remote control batteries are required?
The included remote control requires two AAA batteries. Open the battery compartment on the back of the remote and insert them following the polarity markings.
Is it safe to leave the receiver in standby mode overnight?
Yes, standby mode is designed for safe overnight operation. However, for energy saving, we recommend turning the unit off completely if you will not use it for an extended period.
Where can I find the serial number of my Pioneer 381094-19?
The serial number is located on the rear panel or the bottom of the device. It starts with '381094' and is followed by a dash and the model suffix.
User questions about 381094-19 PIONEER
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
No questions yet. Be the first to ask one.
Download the instructions for your Uncategorized in PDF format for free! Find your manual 381094-19 - PIONEER and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. 381094-19 by PIONEER.