ELECTROLUX

ECT9520G - Range hood ELECTROLUX - Free user manual and instructions

Find the device manual for free ECT9520G ELECTROLUX in PDF.

📄 7 pages English EN Download 💬 AI Question 10 questions ⚙️ Specs
Notice ELECTROLUX ECT9520G - page 1
Pick your language and provide your email: we'll send you a specifically translated version.
Product TypeRange Hood
BrandElectrolux
ModelECT9520G
Installation TypeBuilt-in / Under Cabinet
Width90 cm (35.4 inches)
DepthApprox. 50 cm
HeightAdjustable between 65-105 cm
Net WeightApprox. 15 kg
Power Supply220-240 V, 50 Hz
Max. Extraction RateUp to 720 m³/h
Noise Level45-65 dB(A)
Number of Speeds3 + Boost
Control TypeElectronic push buttons
LightingLED (2 x 3 W)
Filter TypeMetal grease filter, washable
Carbon FilterOptional (recirculation mode)
Ducting150 mm diameter (top or rear)
Energy ClassA+
Annual Energy ConsumptionApprox. 40 kWh
Grease Filter Cleaning IndicatorYes
Safety FeaturesAuto-off timer, thermal motor protection
Spare Parts AvailabilityFilters, bulbs, motor (from authorized service)
Repairability Index8.5 / 10

Frequently Asked Questions - ECT9520G ELECTROLUX

How do I clean the grease filter?
Remove the metal grease filter and wash it by hand with warm soapy water or in a dishwasher at low temperature. Allow it to dry completely before reinstalling.
How often should I replace the carbon filter?
The carbon filter should be replaced every 3 to 6 months depending on usage, especially if the hood is used in recirculation mode.
Why is my range hood making excessive noise?
Check if the grease filter is clean and properly installed. Also ensure the ducting is not blocked. If noise persists, the motor or fan may require service.
Can I install this hood in recirculation mode without ducting?
Yes, you need to purchase an optional carbon filter (model number may vary) and install it according to the manual. The hood will then recirculate filtered air back into the kitchen.
How do I reset the filter cleaning alarm?
After cleaning the grease filter, press and hold the speed button for about 5 seconds until the indicator light turns off. Refer to the manual for exact sequence.
What type of LED bulbs does it use and how to replace them?
The hood uses G4 LED bulbs (3W). To replace, gently remove the light cover and pull out the old bulb. Insert a new one ensuring correct polarity.
What is the maximum duct length for optimal performance?
For best extraction, keep the duct length under 3 meters with minimal bends. Use a 150 mm diameter smooth metal duct.
Does the ECT9520G come with a remote control?
No, this model is controlled via electronic push buttons on the front panel. Some other Electrolux models may include a remote.
Is this range hood suitable for use over an induction hob?
Yes, it is suitable for use over induction, electric, and gas hobs. Ensure the installation height is at least 65 cm above the hob.
How can I access the motor for maintenance?
To access the motor, first remove the grease filter and the internal cover plate. The motor is usually located behind the fan wheel. Disconnect power before any service.

User questions about ECT9520G ELECTROLUX

0 question about this device. Answer the ones you know or ask your own.

Ask a new question about this device

The email remains private: it is only used to notify you if someone responds to your question.

No questions yet. Be the first to ask one.

Download the instructions for your Range hood in PDF format for free! Find your manual ECT9520G - ELECTROLUX and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. ECT9520G by ELECTROLUX.

USER MANUAL ECT9520G ELECTROLUX

Manual assistant
Powered by Anthropic
Waiting for your message
Product information

Brand : ELECTROLUX

Model : ECT9520G

Category : Range hood