Rebel 300 (2012) - Motorcycle Honda - Free user manual and instructions
Find the device manual for free Rebel 300 (2012) Honda in PDF.
Pick your language and provide your email: we'll send you a specifically translated version.
| Product Type | Motorcycle |
| Brand | Honda |
| Model | Rebel 300 (2012) |
| Engine Displacement | 286 cc |
| Engine Type | Air-cooled, 4-stroke, single cylinder |
| Bore x Stroke | 76.0 mm x 63.0 mm |
| Compression Ratio | 9.2:1 |
| Max Power | 22.5 hp @ 7,500 rpm |
| Max Torque | 18.8 lb-ft @ 6,000 rpm |
| Fuel System | PGM-FI (Programmed Fuel Injection) |
| Transmission | 5-speed |
| Final Drive | Chain |
| Front Suspension | Telescopic fork, 33 mm |
| Rear Suspension | Swingarm with dual shocks |
| Front Brake | 240 mm disc with single-piston caliper |
| Rear Brake | 130 mm drum |
| Tires (Front) | 100/90-19 |
| Tires (Rear) | 130/90-15 |
| Length | 81.7 in (2,075 mm) |
| Width | 30.1 in (765 mm) |
| Height | 44.1 in (1,120 mm) |
| Wheelbase | 57.7 in (1,465 mm) |
| Seat Height | 27.2 in (690 mm) |
| Fuel Capacity | 2.7 gallons (10.2 L) |
| Curb Weight | 364 lbs (165 kg) |
Frequently Asked Questions - Rebel 300 (2012) Honda
What is the recommended oil type and capacity?
Use SAE 10W-30 motorcycle oil (API SG or higher, JASO MA). Capacity is approximately 2.2 quarts (2.1 liters) without filter change, 2.4 quarts (2.3 liters) with filter.
How often should I change the oil?
Change the oil every 4,000 miles (6,500 km) or 6 months, whichever comes first. Replace the oil filter every other oil change.
What is the correct tire pressure?
Front tire: 28 psi (193 kPa); Rear tire: 30 psi (207 kPa). Check when tires are cold.
How do I adjust the chain tension?
Loosen the axle nut and adjuster lock nuts. Turn adjuster bolts equally to achieve 20-30 mm (0.8-1.2 in) slack at the center of the lower chain. Tighten lock nuts and axle nut to 65 Nm (48 lb-ft).
What is the fuel consumption?
The Honda Rebel 300 achieves approximately 70-80 mpg (3.0-3.4 L/100 km) under normal riding conditions.
How to check and replace the spark plug?
Remove the spark plug cap and use a 5/8 inch (16 mm) socket. Recommended plug: NGK DPR7EA-9 or ND X24EPR-U9. Gap should be 0.8-0.9 mm (0.031-0.035 in). Torque to 18 Nm (13 lb-ft).
What is the valve clearance specification?
Valve clearance should be checked every 8,000 miles (13,000 km). Cold clearance: Intake 0.15 ± 0.03 mm (0.006 ± 0.001 in), Exhaust 0.20 ± 0.03 mm (0.008 ± 0.001 in).
How do I remove the seat?
Use the ignition key to unlock the seat lock located at the left side of the rear fender. Pull the seat rearward and lift it off.
What type of coolant should I use?
Use a high-quality ethylene glycol-based antifreeze specifically for aluminum engines, mixed with distilled water at a 50/50 ratio. Capacity approximately 1.3 quarts (1.2 L).
How to adjust the headlight beam?
Turn the adjusting screw on the side of the headlight assembly. Aim the headlight so that the beam falls slightly below the horizontal when the motorcycle is on level ground with a rider.
User questions about Rebel 300 (2012) Honda
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
No questions yet. Be the first to ask one.
Download the instructions for your Motorcycle in PDF format for free! Find your manual Rebel 300 (2012) - Honda and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. Rebel 300 (2012) by Honda.
USER MANUAL Rebel 300 (2012) Honda
Manual assistant
Powered by Anthropic
Waiting for your message
Product information
Brand : Honda
Model : Rebel 300 (2012)
Category : Motorcycle