ULTIMO ER-G5143D(SV) - Freezer Elba - Free user manual and instructions
Find the device manual for free ULTIMO ER-G5143D(SV) Elba in PDF.
Pick your language and provide your email: we'll send you a specifically translated version.
| Product Type | Freezer |
| Brand | Elba |
| Model | ULTIMO ER-G5143D(SV) |
| Capacity | 200 L |
| Energy Efficiency Class | A+ |
| Annual Energy Consumption | 200 kWh |
| Climate Class | SN-T |
| Noise Level | 42 dB |
| Temperature Control | Mechanical rotary |
| Defrost Type | Manual |
| Freezing Capacity | 10 kg/24h |
| Storage Time During Power Failure | 12 h |
| Dimensions (H x W x D) | 1450 x 600 x 650 mm |
| Weight | 50 kg |
| Power Supply | 220-240 V, 50 Hz |
| Power Cord Length | 1.5 m |
| Adjustable Thermostat | Yes |
| Interior Light | No |
| Lock | Yes |
| Warranty | 2 years |
| Refrigerant | R600a |
| Installation Type | Freestanding |
| Reversible Door | Yes |
| Number of Drawers | 4 |
| Control Type | Rotary knob |
Frequently Asked Questions - ULTIMO ER-G5143D(SV) Elba
How do I set the temperature on my Elba ULTIMO ER-G5143D(SV) freezer?
Turn the thermostat knob inside the freezer to adjust the temperature. The recommended setting for normal use is '3' or '4' for -18°C. Adjust based on load and ambient temperature.
How often should I defrost the freezer?
Defrost when frost is more than 5 mm thick. Unplug the freezer, remove food, and let ice melt naturally. Clean and dry before restarting. Do not use sharp objects to scrape ice.
What should I do if the freezer is not freezing properly?
Check the thermostat setting and ensure the door is fully closed. Verify that the condenser coils are clean and free of dust. If the problem persists, the compressor may need service.
How do I clean my freezer?
Unplug the freezer. Remove all food and drawers. Wash the interior with a mild detergent and warm water. Rinse and dry thoroughly. Clean the exterior with a soft cloth and stainless steel cleaner if needed.
Can I install the freezer in an unheated garage?
Yes, but the ambient temperature must be within the freezer's climate class (SN-T: 10°C to 43°C). In very cold conditions, the freezer may not maintain proper temperature.
How long does it take to reach -18°C after first plugging in?
It typically takes 4 to 6 hours for the freezer to reach -18°C after initial startup. Avoid opening the door frequently during this period.
Why is there excessive frost build-up in my freezer?
Excessive frost is usually caused by warm air entering the freezer, e.g., due to frequent door openings or a damaged door gasket. Ensure the door seals properly and minimize openings.
How can I change the door swing direction?
The door is reversible. Remove the top hinge and bottom hinge, transfer the door to the opposite side, and reattach the hinges. Refer to the user manual for detailed steps.
What does the red indicator light mean?
The red light indicates that the freezer is not cold enough, e.g., after loading large amounts of warm food or if the door is left open. It will turn off once the internal temperature stabilizes below -12°C.
How can I save energy with my freezer?
Keep the freezer in a cool, well-ventilated area. Avoid placing it near heat sources. Ensure the door gasket is clean and seals properly. Defrost regularly and do not overfill.
User questions about ULTIMO ER-G5143D(SV) Elba
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
No questions yet. Be the first to ask one.
Download the instructions for your Freezer in PDF format for free! Find your manual ULTIMO ER-G5143D(SV) - Elba and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. ULTIMO ER-G5143D(SV) by Elba.
USER MANUAL ULTIMO ER-G5143D(SV) Elba
Manual assistant
Powered by Anthropic
Waiting for your message
Product information
Brand : Elba
Model : ULTIMO ER-G5143D(SV)
Category : Freezer