Black VCO2 - Keyboard Erica Synths - Free user manual and instructions
Find the device manual for free Black VCO2 Erica Synths in PDF.
Pick your language and provide your email: we'll send you a specifically translated version.
| Product Type | Analog VCO Eurorack Module |
| Brand | Erica Synths |
| Model | Black VCO2 |
| Category | Keyboard (Synthesizer Module) |
| Width | 10 HP (50.5 mm) |
| Depth | 35 mm (including ribbon cable) |
| Weight | Approx. 120 g |
| Power Supply | +12V (60 mA), -12V (40 mA) via Eurorack bus |
| Main Functions | Voltage Controlled Oscillator with saw, triangle, square, sine waves; linear and exponential FM; PWM; hard sync; 1V/oct tracking |
| Inputs | 1V/oct CV, FM CV, PWM CV, Sync In |
| Outputs | Saw, Triangle, Square, Sine (simultaneous) |
| Controls | Coarse tune, fine tune, FM amount, PWM depth, frequency range selector (LFO/Audio) |
| Construction | Black aluminum front panel, 2mm thick PCB |
| Care and Cleaning | Wipe with a dry, soft cloth. Avoid solvents. |
| Safety | Low voltage device. Only use in Eurorack case with adequate power. |
| Spare Parts & Repairability | Not user-serviceable. Contact Erica Synths for service. |
| General Information | Designed and manufactured in Latvia. High-quality analog oscillator for modular synthesizers. |
Frequently Asked Questions - Black VCO2 Erica Synths
What is the power consumption of the Black VCO2?
The module draws approximately 60 mA on +12V and 40 mA on -12V.
Can I use the Black VCO2 as an LFO?
Yes, the frequency range switch allows selection between audio rate and LFO mode (down to a few Hz).
What waveforms are available simultaneously?
All four waveforms (saw, triangle, square, sine) are available at the same time on individual outputs.
Does it support frequency modulation?
Yes, it has both linear and exponential FM inputs with dedicated attenuator controls.
How do I calibrate the 1V/oct tracking?
Calibration is factory-set. If needed, adjust the coarse tune and fine tune trimmers inside the module. Refer to the manual.
What is the output voltage level?
Outputs are typically 10V peak-to-peak (5V amplitude) for saw and square, slightly lower for triangle and sine.
Can I sync multiple oscillators?
Yes, the hard sync input allows syncing the oscillator to an external signal, resetting the waveform cycle.
Is the Black VCO2 through-hole or SMD?
It uses SMD components for compactness, but all circuit are through-hole for easy DIY repairs if needed.
What type of PWM does it have?
Pulse width modulation (PWM) is available on the square wave output, controlled by a CV input and manual knob.
How do I clean the module?
Disconnect power, then wipe the front panel with a dry, soft cloth. Do not use liquids or abrasive cleaners.
User questions about Black VCO2 Erica Synths
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
No questions yet. Be the first to ask one.
Download the instructions for your Keyboard in PDF format for free! Find your manual Black VCO2 - Erica Synths and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. Black VCO2 by Erica Synths.
USER MANUAL Black VCO2 Erica Synths
Manual assistant
Powered by Anthropic
Waiting for your message
Product information
Brand : Erica Synths
Model : Black VCO2
Category : Keyboard