HTA-700B v.3-USB - Uncategorized Taga Harmony - Free user manual and instructions
Find the device manual for free HTA-700B v.3-USB Taga Harmony in PDF.
Pick your language and provide your email: we'll send you a specifically translated version.
| Product Type | Integrated Hybrid Tube Amplifier with USB DAC |
| Brand | Taga Harmony |
| Model | HTA-700B v.3-USB |
| Power Output | 2 x 50W RMS (8 ohms) |
| Frequency Response | 20 Hz - 20 kHz (+/- 0.5 dB) |
| Input Impedance | 47k ohms |
| Speaker Impedance | 4-8 ohms |
| Total Harmonic Distortion | < 0.1% |
| Signal-to-Noise Ratio | > 90 dB |
| Tube Complement | 2 x 12AX7 (pre-amp), 2 x 12AU7 (driver) |
| Inputs | 3 x RCA (Line 1, Line 2, Phono MM), 1 x USB-B (asynchronous) |
| Outputs | 1 x Speaker (binding posts), 1 x Pre-out (RCA) |
| USB DAC Resolution | Up to 24-bit/192kHz (PCM) |
| Power Supply | AC 110-240V, 50/60Hz (internal) |
| Dimensions (W x D x H) | 430 x 320 x 120 mm |
| Weight | 8.5 kg |
| Remote Control | Included (IR) |
| Accessories Included | Power cord, remote control, user manual |
| Safety Features | Overload protection, speaker short-circuit protection |
| Maintenance | Dust with dry cloth; tube replacement every 3-5 years depending on use |
| Repairability | Spare parts available via authorized service centers |
Frequently Asked Questions - HTA-700B v.3-USB Taga Harmony
What is the power output of the HTA-700B v.3-USB?
The amplifier delivers 2 x 50W RMS into 8 ohms, suitable for most bookshelf and floorstanding speakers.
Which vacuum tubes are used in this model?
It uses two 12AX7 tubes in the preamp stage and two 12AU7 tubes as drivers.
Can I connect a turntable directly?
Yes, the HTA-700B v.3-USB has a dedicated Phono (MM) input for moving magnet cartridges.
How do I connect via USB?
Use a standard USB-B cable to connect your computer. The amplifier supports asynchronous USB audio up to 24-bit/192kHz.
Does the amplifier include a remote control?
Yes, an IR remote is included for volume, input selection, and power.
What safety precautions should I observe?
Avoid exposing the unit to moisture. Ensure proper ventilation. The amplifier has built-in overload and short-circuit protection.
How often should I replace the tubes?
Tubes typically last 3-5 years with normal use. If you notice distortion or reduced volume, consider replacing them.
Can I use speakers with 4 ohm impedance?
Yes, the amplifier is stable with 4-8 ohm speakers. Ensure proper cooling when driving low-impedance loads.
Does the USB DAC support DSD?
No, the USB DAC supports PCM only up to 24-bit/192kHz. DSD playback is not supported.
Where can I find spare parts?
Spare parts and service are available through authorized Taga Harmony service centers. Check the brand's website for local distributors.
User questions about HTA-700B v.3-USB Taga Harmony
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
No questions yet. Be the first to ask one.
Download the instructions for your Uncategorized in PDF format for free! Find your manual HTA-700B v.3-USB - Taga Harmony and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. HTA-700B v.3-USB by Taga Harmony.
USER MANUAL HTA-700B v.3-USB Taga Harmony
Manual assistant
Powered by Anthropic
Waiting for your message
Product information
Brand : Taga Harmony
Model : HTA-700B v.3-USB
Category : Uncategorized