KGC26BNA - Water heater KELVINATOR - Free user manual and instructions
Find the device manual for free KGC26BNA KELVINATOR in PDF.
Pick your language and provide your email: we'll send you a specifically translated version.
| Product Type | Gas Water Heater |
| Brand | Kelvinator |
| Model | KGC26BNA |
| Capacity | 26 gallons |
| Energy Source | Natural Gas or Propane |
| Ignition Type | Electronic |
| Input Rate (BTU/h) | 36,000 |
| Dimensions (H x W x D) | 38 x 20 x 20 inches |
| Weight | 120 lbs |
| Installation | Indoor, vented |
| Venting | Power vent |
| Safety Features | Flame failure safety, Overheat protection, Temperature and pressure relief valve |
| Control Type | Thermostat with pilot light |
| First Hour Rating | 67 gallons |
| Maximum Temperature Setting | 160°F (71°C) |
| Fuel Efficiency (Energy Factor) | 0.60 |
| Warranty | 6 years limited tank warranty |
| Maintenance | Drain and flush annually; check anode rod |
| Replacement Parts | Thermostat, thermocouple, anode rod, gas control valve |
| User Manual | Available for free download in PDF |
Frequently Asked Questions - KGC26BNA KELVINATOR
How do I light the pilot on my Kelvinator KGC26BNA water heater?
Follow the lighting instructions on the water heater label. Typically, turn the gas control knob to 'Pilot', press and hold the knob, and use a lighter to ignite the pilot. Continue holding for about 30 seconds after the flame appears, then release and turn knob to 'ON'.
What does the KGC26BNA model number indicate?
The '26' indicates a 26-gallon capacity. 'BNA' is a series designation. Kelvinator is the brand, and this is a gas-powered water heater.
Why is my water heater not heating water?
Check if the pilot light is on. If not, relight it. If the pilot is on but water is cold, the thermostat may be faulty or the gas control valve may need replacement. Also ensure the temperature setting is not too low.
How do I drain and flush the water heater?
Turn off the gas supply and cold water inlet. Attach a garden hose to the drain valve at the bottom. Open a hot water faucet to vent. Open the drain valve and let the water flow out. Flush by opening the cold water inlet for a few seconds. Close drain valve, remove hose, and turn water and gas back on.
What is the recommended temperature setting?
For energy efficiency and safety, set the thermostat to 120°F (49°C). Higher temperatures increase scald risk and energy use.
How often should I replace the anode rod?
The anode rod should be inspected annually and replaced every 3-5 years, or more often if the water is hard. A depleted anode rod can lead to tank corrosion.
Where can I find replacement parts for the KGC26BNA?
Parts such as thermostats, thermocouples, and gas control valves can be found online or at plumbing supply stores. Use the model number to ensure compatibility.
Is the Kelvinator KGC26BNA suitable for mobile homes?
Check the manual for specific clearance requirements. Generally, water heaters installed in mobile homes must meet HUD standards; this model may be approved for mobile home use if specified.
How do I know if my water heater is leaking?
Inspect the area around the tank for water puddles or rust. Leaks often come from the temperature and pressure relief valve, drain valve, or from a crack in the tank. If the tank itself is leaking, it needs replacement.
What does the flashing LED on the gas control valve mean?
The LED indicates error codes. Refer to the manual for specific flash patterns. Common codes: one flash = ignition failure, two flashes = pilot flame sense error, three flashes = thermopile voltage low.
User questions about KGC26BNA KELVINATOR
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
No questions yet. Be the first to ask one.
Download the instructions for your Water heater in PDF format for free! Find your manual KGC26BNA - KELVINATOR and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. KGC26BNA by KELVINATOR.
USER MANUAL KGC26BNA KELVINATOR
Manual assistant
Powered by Anthropic
Waiting for your message
Product information
Brand : KELVINATOR
Model : KGC26BNA
Category : Water heater