DXY-1150A - Uncategorized ROLAND - Free user manual and instructions
Find the device manual for free DXY-1150A ROLAND in PDF.
Pick your language and provide your email: we'll send you a specifically translated version.
| Product Type | Pen Plotter |
| Model | DXY-1150A |
| Brand | Roland |
| Dimensions (W x D x H) | Approximately 1150 x 350 x 200 mm |
| Weight | Approximately 12 kg |
| Power Supply | AC 100-240V, 50/60 Hz |
| Power Consumption | Approximately 60 W (operating) |
| Plotting Area | Up to A1 size (594 x 841 mm) |
| Pen Type | Fiber-tip, water-based or oil-based pens |
| Number of Pens | 8 pen carousel (automatic exchange) |
| Resolution | 0.025 mm (mechanical) 0.0125 mm (programmable) |
| Maximum Plotting Speed | 600 mm/s (diagonal) |
| Interface | RS-232C serial, Centronics parallel |
| Command Language | Roland DG RTL, HP-GL |
| Media Type | Paper, film, adhesive sheet (roll or sheet) |
| Media Hold | Pinch roller and grit wheel |
| Offline Buffer | 512 KB |
| Maintenance | Clean grit wheels and pinch rollers periodically; replace pen tips as needed. |
| Safety Features | Emergency stop; overheating protection; cover interlock |
| Repairability | Replaceable pen carousel, servo motor, and logic board; service manual available |
| Included Accessories | Power cord, RS-232 cable, sample pens, user manual |
Frequently Asked Questions - DXY-1150A ROLAND
What type of ink does the Roland DXY-1150A support?
The plotter accepts fiber-tip pens with water-based or oil-based ink. Use Roland-recommended refills for best results.
How do I load a paper roll?
Place the roll on the spool, feed the edge under the grit wheels, and lower the pinch rollers. Adjust the media stops and confirm alignment. The plotter will auto-feed if enabled.
The pen is not plotting correctly. What should I check?
First, ensure the pen tip is not dried out. Replace it if necessary. Next, check that the proper pen type is selected in the plotter settings. Also verify that the media is flat and the grit wheels are clean.
How do I connect the DXY-1150A to a computer?
Use a standard RS-232 serial cable (9-pin) or a Centronics parallel cable. Set the correct baud rate and handshake in the plotter menu to match your computer's settings.
What is the maximum plot size?
The maximum plot area is A1 size (594 x 841 mm). For longer plots, you can use roll media up to 42 inches wide, but the effective width is slightly less.
How do I perform a pen alignment?
Go to the utility menu and select 'Pen Calibration'. The plotter will draw a test pattern. Use the adjustment screws to align the pen holder so that all pens plot at the same position.
Can I use HP-GL commands with this plotter?
Yes, the DXY-1150A supports both Roland DG's own language (RTL) and HP-GL. Make sure to set the command mode via the front panel before sending data.
The plotter stops mid-plot. What could be wrong?
Check for a paper jam, empty pen, or loose cable. Also verify the plot file is not corrupted. If the plotter shows an error code, refer to the manual for specific troubleshooting.
How often should I clean the grit wheels?
Clean the grit wheels every 20-30 hours of operation or when you notice media feeding issues. Use a soft brush or compressed air to remove dust and paper debris.
Where can I find replacement pens?
Replacement pens and refills are available from Roland authorized dealers or online. Use the correct model (Roland DXY series pens) to avoid damage to the pen carousel.
User questions about DXY-1150A ROLAND
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
No questions yet. Be the first to ask one.
Download the instructions for your Uncategorized in PDF format for free! Find your manual DXY-1150A - ROLAND and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. DXY-1150A by ROLAND.
USER MANUAL DXY-1150A ROLAND
Manual assistant
Powered by Anthropic
Waiting for your message
Product information
Brand : ROLAND
Model : DXY-1150A
Category : Uncategorized