Solis - Receiver REGA - Free user manual and instructions
Find the device manual for free Solis REGA in PDF.
Pick your language and provide your email: we'll send you a specifically translated version.
| Product Type | Stereo Integrated Amplifier / Receiver |
| Brand | Rega |
| Model | Solis |
| Dimensions (W x H x D) | 432 x 87 x 340 mm |
| Weight | 8 kg |
| Power Consumption | 250 W (max) |
| Standby Power | < 0.5 W |
| Inputs | 4x RCA line, 1x Phono (MM), 1x Optical, 1x Coaxial |
| Outputs | Speakers (A/B), Pre-out, Record out |
| Power Output | 70W per channel (8 ohms) |
| Frequency Response | 20 Hz – 20 kHz ± 0.5 dB |
| Total Harmonic Distortion | < 0.03% |
| Signal-to-Noise Ratio | > 80 dB (line) |
| Phono Stage | Moving Magnet (MM) compatible |
| Remote Control | Included (infrared) |
| Functions | Volume, input selection, balance, tone controls (bass/treble), mute |
| Maintenance | Clean with soft, dry cloth; do not use solvents. |
| Safety | Disconnect power before cleaning; do not expose to moisture or heat sources. |
| Spare Parts & Repair | Contact authorized Rega service center. |
| Country of Design | United Kingdom |
Frequently Asked Questions - Solis REGA
How do I connect my turntable to the Rega Solis?
Connect your turntable to the Phono input. Ensure the turntable has a moving magnet (MM) cartridge. If it has a moving coil (MC), you may need an external phono preamp.
Can I use banana plugs with the speaker terminals?
Yes, the speaker terminals accept banana plugs, spade connectors, or bare wire. Remove the plastic caps before inserting banana plugs.
What is the power output of the Solis?
The Solis delivers 70W per channel into 8 ohms, sufficient for most home speakers.
How do I reset the amplifier if it shuts down?
If the amplifier enters protection mode, turn it off, disconnect the power, wait 10 minutes, and reconnect. Ensure proper ventilation and speaker impedance.
Does the Solis have a headphone output?
No, the Solis does not include a dedicated headphone output. Use an external headphone amplifier connected to the pre-out.
Can I bi-wire my speakers?
Yes, the Solis has two sets of speaker outputs (A and B). Connect the high and low frequency terminals separately to each output for bi-wiring.
How do I clean the Solis?
Use a soft, dry cloth. Avoid solvents, abrasive cleaners, or water. Unplug before cleaning.
What is the recommended speaker impedance?
The Solis is designed for speakers with an impedance of 4 to 8 ohms.
Where can I find the serial number?
The serial number is located on the rear panel near the power cord or on the underside of the unit.
Does the Solis include a DAC?
Yes, the Solis has built-in DAC with optical and coaxial inputs, supporting PCM up to 24-bit/192kHz.
User questions about Solis REGA
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
No questions yet. Be the first to ask one.
Download the instructions for your Receiver in PDF format for free! Find your manual Solis - REGA and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. Solis by REGA.
USER MANUAL Solis REGA
Manual assistant
Powered by Anthropic
Waiting for your message
Product information
Brand : REGA
Model : Solis
Category : Receiver