BE1200.1D - Receiver BOSS - Free user manual and instructions
Find the device manual for free BE1200.1D BOSS in PDF.
Pick your language and provide your email: we'll send you a specifically translated version.
| Product Type | Monoblock Car Audio Amplifier |
| Model | BE1200.1D |
| Brand | Boss |
| Power Output (RMS) | 600W x 1 @ 4 ohms, 1200W x 1 @ 2 ohms |
| Peak Power | 2400W |
| Frequency Response | 20Hz - 250Hz |
| Signal-to-Noise Ratio | ≥ 90 dB |
| Input Sensitivity | 200mV - 6V |
| Low Pass Filter | 50Hz - 250Hz adjustable |
| Bass Boost | 0 - 12 dB at 45Hz |
| Subsonic Filter | 20Hz (fixed) |
| Dimensions (W x L x H) | 10.5 x 7.5 x 1.9 inches |
| Weight | 4.4 lbs |
| Power Supply | 12V DC (10-15V) |
| Fuse Rating | 30A x 2 |
| Channels | 1 |
| Load Impedance | 2 - 8 ohms |
| Maintenance | Clean with dry cloth; avoid liquids |
| Safety | Disconnect battery before installation; do not expose to moisture |
| Warranty | 1 year limited |
Frequently Asked Questions - BE1200.1D BOSS
What is the RMS power output of the Boss BE1200.1D?
The RMS power output is 600W at 4 ohms and 1200W at 2 ohms.
Can this amplifier be bridged?
No, the BE1200.1D is a monoblock amplifier and cannot be bridged further. It is designed to power a single subwoofer.
What is the size of the power and ground wire recommended?
A minimum of 4 AWG power and ground wire is recommended for optimal performance.
What is the low-pass filter range?
The low-pass filter is adjustable from 50Hz to 250Hz.
Does the amplifier have a remote bass level control?
Yes, it includes a wired remote bass level control (sold separately or included depending on package).
What is the recommended fuse size?
The amplifier uses two 30A fuses, so a 60A inline fuse on the power wire is recommended.
Can I use this amplifier with a factory radio?
Yes, but you will need a line output converter (LOC) to convert speaker-level signals to RCA.
What should I do if the amplifier goes into protect mode?
Check for shorts in speaker wires, proper ground connection, and ensure the impedance is not too low. Also verify the power supply voltage.
How do I adjust the gain setting?
Set the gain to minimum, play a test tone at 50Hz, then gradually increase until you hear distortion, then back off slightly.
Is this amplifier stable at 1 ohm?
No, the BE1200.1D is only stable down to 2 ohms. Do not use a 1 ohm load as it may damage the amplifier.
User questions about BE1200.1D BOSS
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
No questions yet. Be the first to ask one.
Download the instructions for your Receiver in PDF format for free! Find your manual BE1200.1D - BOSS and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. BE1200.1D by BOSS.
USER MANUAL BE1200.1D BOSS
Manual assistant
Powered by Anthropic
Waiting for your message
Product information
Brand : BOSS
Model : BE1200.1D
Category : Receiver