D4 - Uncategorized Cameo - Free user manual and instructions
Find the device manual for free D4 Cameo in PDF.
Pick your language and provide your email: we'll send you a specifically translated version.
| Product Type | DMX Dimmer Pack |
| Channels | 4 |
| Power Supply | AC 230V, 50/60Hz |
| Max Load per Channel | 10 A (resistive) |
| DMX Connector | 3-pin XLR (in/out) |
| Dimensions (WxDxH) | 483 x 150 x 88 mm |
| Weight | 2.5 kg |
| Housing | Metal, 19" rackmount |
| Cooling | Fan |
| Protection Features | Overload, short circuit, over temperature |
| Control Modes | DMX, Standalone, Manual |
| Fade Time | Adjustable 0–10 seconds |
| Preprogrammed Scenes | 8 built-in chase patterns |
| DMX Address Setting | Rotary dial or DIP switches |
| Display | LED indicators per channel |
| Operating temperature | 0°C to 40°C |
| Certifications | CE, EMC |
| Included Accessories | Power cord, manual |
Frequently Asked Questions - D4 Cameo
How do I set the DMX address on the Cameo D4?
Turn off the unit. Use the rotary dial or DIP switches on the rear panel to set the desired DMX address. Refer to the manual for binary settings if using DIP switches.
What is the maximum load per channel?
Each channel can handle up to 10 A for resistive loads (e.g., incandescent lamps). For inductive loads, reduce to 5 A.
Can I use the D4 in standalone mode without a DMX controller?
Yes. Select standalone mode via the front panel. Then choose a built-in chase program and adjust speed using the controls.
Why is one channel not working?
Check the fuse on that channel (if equipped). Also verify the DMX connection and channel address. Overload may have tripped protection.
How do I perform a factory reset?
Turn off the unit. Press and hold the 'Walk' button while powering on. Hold until all LEDs flash, then release.
What type of cable do I need for DMX connection?
Use standard DMX512 cable with 3-pin XLR connectors. Avoid using audio cables as they may cause data errors.
Can I daisy-chain multiple D4 units?
Yes, connect the DMX out of the first unit to the DMX in of the next. Ensure proper termination with a 120 ohm resistor at the last unit.
The fan is noisy – is that normal?
The fan is temperature-controlled. Under heavy load, it runs at full speed and may be audible. Ensure proper ventilation and clean dust regularly.
What is the fuse rating for the mains input?
The mains fuse is 2A (250V) 5x20mm. Always replace with the same rating.
How do I clean the Cameo D4?
Disconnect power. Use a soft dry cloth to wipe the exterior. For vents, use compressed air. Avoid wet cleaners inside.
User questions about D4 Cameo
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
No questions yet. Be the first to ask one.
Download the instructions for your Uncategorized in PDF format for free! Find your manual D4 - Cameo and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. D4 by Cameo.
USER MANUAL D4 Cameo
Manual assistant
Powered by Anthropic
Waiting for your message
Product information
Brand : Cameo
Model : D4
Category : Uncategorized