ME Super - Camera PENTAX - Free user manual and instructions
Find the device manual for free ME Super PENTAX in PDF.
Pick your language and provide your email: we'll send you a specifically translated version.
| Product Type | 35mm SLR Film Camera |
| Lens Mount | Pentax K |
| Shutter Type | Metal vertical-travel focal plane |
| Shutter Speeds | Auto: 4s to 1/2000s; Manual: 4s to 1/2000s plus B |
| Exposure Control | Aperture-priority auto, full manual |
| Metering | Center-weighted average; EV 1 to 18 (ISO 100, f/1.4) |
| Viewfinder | Pentaprism with 92% coverage, 0.95x magnification |
| Film Speed | ISO 12 to 3200 |
| Flash Sync | X-sync at 1/125s; hot shoe and PC terminal |
| Self-Timer | Mechanical, approx. 10s delay |
| Battery | Two 1.5V LR44/SR44 or equivalent |
| Dimensions | 135.5 x 87 x 50 mm (5.3 x 3.4 x 2.0 in) |
| Weight | 490 g (1.08 lb) with batteries |
| Film Loading | Manual advance, auto rewind with optional winder |
| Lens Compatibility | Pentax K-mount lenses (SMC, M, A series) |
| Maintenance | Clean lens with soft cloth; keep camera dry; store in cool place |
| Safety | Avoid extreme temperatures and humidity; remove battery if not used for long periods |
| Spare Parts | Batteries, eyecup, hot shoe cover available; repairs by authorized service centers |
Frequently Asked Questions - ME Super PENTAX
How do I load film into the Pentax ME Super?
Open the back by pulling up the rewind knob. Insert the film cassette into the left chamber, pull the leader across to the take-up spool, and ensure the sprocket teeth engage the film perforations. Close the back and advance the film using the advance lever until the frame counter reads 1.
How do I set the film speed (ISO)?
Lift and rotate the film speed dial (located on the top plate, left side) until the desired ISO value aligns with the index mark. The dial ranges from ISO 12 to 3200.
What batteries does the ME Super use?
It uses two 1.5V LR44 or SR44 batteries (alkaline or silver oxide). Install them in the compartment under the camera base, observing polarity.
How do I check the battery status?
Turn the mode switch to Auto and press the shutter button halfway. If the red LED in the viewfinder blinks, the batteries are weak and should be replaced.
What is the self-timer procedure?
Set the self-timer lever (located near the shutter button) downward. Press the shutter button; the lever will start moving and the shutter fires after approximately 10 seconds.
How do I use manual exposure mode?
Turn the mode switch to M. Look through the viewfinder and set the aperture and shutter speed until the LEDs indicate correct exposure: green LED for proper, red arrows for over/under.
Can I use modern Pentax lenses on the ME Super?
Yes, the ME Super uses the Pentax K mount, so all K-mount lenses (including K, M, A, and some later compatible lenses) work. For autofocus lenses, only manual focus is possible.
How do I rewind film?
Press the rewind button (small button on the bottom of the camera). Release the film advance by pressing the rewind release alongside. Then crank the rewind knob clockwise until you feel the film detach.
What flash units are compatible?
Any hot shoe flash with a single center contact works. For dedicated functionality (e.g., auto flash), use Pentax AF-series flashes. The sync speed is 1/125s.
How should I clean the lens?
Use a soft brush to remove dust, then a microfiber cloth with lens cleaning solution. Wipe gently from center outward. Avoid touching the glass with fingers.
User questions about ME Super PENTAX
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
No questions yet. Be the first to ask one.
Download the instructions for your Camera in PDF format for free! Find your manual ME Super - PENTAX and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. ME Super by PENTAX.