WTF-F800 - Effect machine Showtec - Free user manual and instructions
Find the device manual for free WTF-F800 Showtec in PDF.
Pick your language and provide your email: we'll send you a specifically translated version.
| Product Type | Effect Machine (Fog Machine) |
| Model | WTF-F800 |
| Brand | Showtec |
| Power Consumption | 800 W |
| Voltage | 230 V / 50 Hz |
| Warm-up Time | Approx. 3 minutes |
| Fluid Tank Capacity | 0.8 L |
| Output (Fog Volume) | Approx. 4,000 cfm at full output |
| Remote Control | Wired remote with 5 m cable included |
| Dimensions (L x W x H) | 350 x 220 x 200 mm |
| Weight | 4.2 kg |
| Housing Material | Metal and high-temperature plastic |
| Heater Type | High-efficiency heat exchanger |
| Fluid Type | Water-based fog fluid (standard or low-lying) |
| Max. Continuous Run Time | Up to 30 minutes (depending on output) |
| Protection Class | IP20 (indoor use only) |
| Safety Features | Thermal cut-off, non-slip feet, fluid level detection |
| Maintenance | Regular cleaning of nozzle with distilled water; descaling every 40 hours of use |
| Spare Parts Available | Heater, pump, remote control, fluid tank, fuses |
| Reparability | Modular design allows easy replacement of main components by qualified technician |
Frequently Asked Questions - WTF-F800 Showtec
How do I set up the Showtec WTF-F800 for the first time?
Place the machine on a stable, level surface. Fill the tank with water-based fog fluid. Connect the remote control and plug into a grounded outlet. Allow 3 minutes warm-up before use.
What type of fluid should I use?
Use only Showtec approved water-based fog fluid (standard or low-lying). Do not use oil-based fluids, as they can damage the heater.
The machine is not producing fog. What should I check?
Ensure the fluid tank is not empty. Check if the machine has warmed up completely (green LED on remote). Verify the remote is connected properly. If still no fog, the heater or pump may need servicing.
Can I use the WTF-F800 outdoors?
This machine is rated IP20 and is intended for indoor use only. Avoid exposure to rain, moisture, or extreme temperatures.
How often should I clean the machine?
After every 40 hours of operation, flush the system with distilled water to remove mineral deposits. Wipe the exterior with a dry cloth.
What does the red LED on the remote indicate?
The red LED indicates that the machine is heating up. When it turns green, the machine is ready to output fog.
Can I use a wireless remote controller?
The WTF-F800 comes with a wired remote. For wireless control, you can use an optional Showtec DMX controller or a wireless relay (not included).
The machine leaks fluid. What should I do?
Check that the tank cap is tightened securely. Ensure the machine is level. If leaking persists, the tank may be cracked or the pump seal damaged. Contact support.
How do I replace the fuse?
Disconnect the machine from power. Locate the fuse holder near the power input. Use a flat screwdriver to open it and replace with a 5x20mm 10A fuse (provided). Reassemble.
Is the machine safe to use around people and animals?
Yes, when used with water-based fog fluid, the fog is non-toxic and safe. Avoid direct inhalation for extended periods. Ensure ventilation as per local regulations.
User questions about WTF-F800 Showtec
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
No questions yet. Be the first to ask one.
Download the instructions for your Effect machine in PDF format for free! Find your manual WTF-F800 - Showtec and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. WTF-F800 by Showtec.
USER MANUAL WTF-F800 Showtec
Manual assistant
Powered by Anthropic
Waiting for your message
Product information
Brand : Showtec
Model : WTF-F800
Category : Effect machine