IP060160C - Boiler Rinnai - Free user manual and instructions
Find the device manual for free IP060160C Rinnai in PDF.
Pick your language and provide your email: we'll send you a specifically translated version.
| Type | Gas boiler (condensing) |
| Brand | Rinnai |
| Model | IP060160C |
| Energy Source | Natural gas / Propane |
| Heating Output | 24 kW |
| Hot Water Output | 28 kW |
| Dimensions (H x W x D) | 700 mm x 430 mm x 300 mm |
| Weight | 35 kg |
| Power Supply | 230 V / 50 Hz |
| Gas Connection | 3/4" BSP |
| Water Connection | 3/4" BSP (heating) / 1/2" BSP (DHW) |
| Flue Type | Room sealed |
| Control Interface | Digital display with push buttons |
| Functions | Central heating, domestic hot water, frost protection, summer/winter mode |
| Built-in Components | Pump, expansion vessel, 3-way valve, safety valve |
| Maintenance | Annual professional service; clean primary heat exchanger and DHW plate heat exchanger |
| Safety Features | Flame failure, overheat cut-out, low water pressure cutoff, frost protection |
| Compliance | CE, ErP Directive 2009/125/EC |
| Warranty | 2 years (parts and labor) |
| Spare Parts Availability | Through Rinnai authorized service centers |
| Repairability Index | 7.5 / 10 (estimated) |
Frequently Asked Questions - IP060160C Rinnai
How do I reset the boiler after a fault?
Press and hold the reset button on the control panel for 3 seconds. Make sure the power and gas supply are on.
What error code E01 means?
Error E01 indicates a flame failure. Check gas valve is open, gas pressure is adequate, and ignition electrodes are clean.
How often should I service the boiler?
An annual service by a gas-safe registered engineer is recommended to ensure safety and efficiency.
Can I use the boiler if water pressure is too low?
No, the boiler may lock out if pressure drops below 0.5 bar. Repressurize the system using the filling loop.
How do I adjust the water temperature?
Use the temperature control knobs on the front panel. Turn clockwise to increase temperature, counterclockwise to decrease.
What is the maximum heating area for this boiler?
Approximately 200 m² for a typical well-insulated home, depending on heat loss.
Is the boiler compatible with underfloor heating?
Yes, but a mixing valve or thermostatic control should be installed to limit flow temperature.
How do I clean the condensate trap?
Turn off the boiler, remove the trap cover, and flush with warm water. Reinstall securely. Do this during annual service.
Where is the drain point for the heating circuit?
The drain valve is located at the bottom of the boiler or on the nearest radiator. Use a hose to drain.
How do I interpret the LED status lights?
A steady green LED indicates normal operation. Flashing red means a fault; consult the manual for specific codes.
User questions about IP060160C Rinnai
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
No questions yet. Be the first to ask one.
Download the instructions for your Boiler in PDF format for free! Find your manual IP060160C - Rinnai and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. IP060160C by Rinnai.
USER MANUAL IP060160C Rinnai
Manual assistant
Powered by Anthropic
Waiting for your message
Product information
Brand : Rinnai
Model : IP060160C
Category : Boiler