LXi - Heating Jandy - Free user manual and instructions
Find the device manual for free LXi Jandy in PDF.
Pick your language and provide your email: we'll send you a specifically translated version.
| Product Type | Pool/Spa Heater |
| Brand | Jandy |
| Model | LXi |
| Fuel Type | Natural Gas or Propane |
| Heating Capacity | Up to 400,000 BTU/hr |
| Ignition Type | Electronic Ignition |
| Control System | Digital Thermostat with LED Display |
| Efficiency Rating | Up to 84% Thermal Efficiency |
| Dimensions (L x W x H) | 34 x 22 x 28 inches |
| Weight | 120 lbs |
| Power Supply | 120V AC, 60 Hz |
| Water Flow Rate | 20-100 GPM |
| Heat Exchanger Material | Copper and Stainless Steel |
| Safety Features | Flame Sensing, Overheat Protection, Pressure Switch |
| Corrosion Resistance | Polypropylene Cabinet |
| Certifications | ANSI Z21.56, CSA 4.10 |
| Warranty | 3 Years (Parts & Labor) |
| Compatible Pools | Residential In-Ground and Above-Ground |
| Installation Type | Outdoor, Rooftop, or Indoor with Proper Ventilation |
| Low NOx Emissions | Yes, meets SCAQMD standards |
Frequently Asked Questions - LXi Jandy
What fuel types does the Jandy LXi heater support?
The Jandy LXi supports natural gas and propane. Conversion kits are available if needed.
How do I clean the heat exchanger?
Turn off power and gas. Remove the top panel and use a soft brush to gently clean the fins. Avoid damaging the tubes. Refer to the manual for detailed steps.
What does error code 'FL' mean?
Error code 'FL' indicates a flame lockout. This may be due to gas supply issues, dirty igniter, or blocked venturi. Reset the heater and check for obstructions.
How often should I replace the anode rod?
Inspect annually and replace every 3-5 years or when more than 50% corroded. Use a compatible anode for your water chemistry.
Can the Jandy LXi be installed indoors?
Yes, but it requires proper ventilation and must comply with local codes. An indoor installation kit may be necessary.
What is the optimal water flow rate?
The recommended flow rate is 20-100 GPM. Lower flow may cause overheating; higher flow reduces efficiency.
How do I winterize the heater?
Drain all water from the heat exchanger and piping. Disconnect gas and power, and store the heater in a dry, sheltered area if possible.
Why is my heater not igniting?
Check the gas valve, igniter, and flame sensor. Ensure the power is on and the thermostat is set above water temperature. Clean or replace components as needed.
What is the efficiency rating?
The Jandy LXi achieves up to 84% thermal efficiency, reducing fuel costs compared to standard heaters.
Where can I find replacement parts?
Authorized Jandy dealers or online retailers stock OEM parts. Use the model number LXi to find compatible components.
User questions about LXi Jandy
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
No questions yet. Be the first to ask one.
Download the instructions for your Heating in PDF format for free! Find your manual LXi - Jandy and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. LXi by Jandy.
USER MANUAL LXi Jandy
Manual assistant
Powered by Anthropic
Waiting for your message
Product information
Brand : Jandy
Model : LXi
Category : Heating