C53 - Receiver MCINTOSH - Free user manual and instructions
Find the device manual for free C53 MCINTOSH in PDF.
Pick your language and provide your email: we'll send you a specifically translated version.
| Product Type | Solid-State Stereo Receiver with AM/FM Tuner |
| Dimensions (W x H x D) | 17.5 x 7 x 18 inches (44.5 x 17.8 x 45.7 cm) |
| Weight | 30 lbs (13.6 kg) |
| Power Supply | 120V AC, 50/60Hz |
| Power Output | 100 Watts per channel into 8 ohms (RMS) |
| Frequency Response | 20Hz – 20kHz ±0.5dB |
| Total Harmonic Distortion (THD) | <0.005% at rated output |
| Signal-to-Noise Ratio | 100dB (line input) |
| Phono Input | Yes, with MM/MC selector |
| Tuner Bands | AM and FM with 8 presets each |
| Inputs | 5 line-level, 1 phono, 1 tape |
| Outputs | Preamp out, tape out, 2 pairs of speaker outputs (A/B) |
| Headphone Jack | 1/4-inch on front panel |
| Tone Controls | Bass and treble, ±12dB at 50Hz and 10kHz |
| Loudness Compensation | Yes, selectable |
| Remote Control | Infrared, included |
| Finish Options | Black or silver front panel |
| Cleaning Instructions | Wipe with a soft, dry cloth; avoid liquids and abrasives |
| Safety Features | AC line fuse, thermal shutdown, speaker protection relay |
| Repairability | McIntosh authorized service centers; some parts available through service |
Frequently Asked Questions - C53 MCINTOSH
How do I connect external speakers?
Use the speaker A or B terminals on the rear panel. Ensure impedance is 8 ohms or higher for optimal performance.
Can I use the C53 with a turntable?
Yes, the C53 has a dedicated phono input. Select the MM or MC setting via the rear switch depending on your cartridge type.
How do I clean the front panel?
Use a soft, lint-free microfiber cloth slightly dampened with water. Do not use any solvents or abrasive cleaners.
What is the power output per channel?
The C53 delivers 100 watts RMS per channel into 8 ohms, with both channels driven.
How do I reset the tuner presets?
Press and hold the 'Memory' button for 3 seconds until the display flashes. Then use the tuning knob to select preset numbers and store stations.
Is the C53 compatible with subwoofers?
Yes, you can connect a powered subwoofer using the preamp output jacks, or use the speaker-level inputs if the subwoofer supports them.
What should I do if the unit overheats?
Ensure adequate ventilation around the receiver. If the thermal shutdown activates, power off, let it cool for 30 minutes, then reduce volume or improve air circulation.
Can I bi-amp my speakers with this receiver?
The C53 has only one set of amplifier outputs per channel, so bi-amping is not supported. You would need an external crossover and separate amplifier.
How do I replace the fuse?
Unplug the unit. Locate the fuse holder beside the IEC power inlet. Use a 2.5A 250V slow-blow fuse of the same type. If it blows again, consult a technician.
Where can I find the serial number?
The serial number is located on the rear panel near the power cord. It is also printed on the original packaging and registration card.
User questions about C53 MCINTOSH
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
No questions yet. Be the first to ask one.
Download the instructions for your Receiver in PDF format for free! Find your manual C53 - MCINTOSH and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. C53 by MCINTOSH.
USER MANUAL C53 MCINTOSH
Manual assistant
Powered by Anthropic
Waiting for your message
Product information
Brand : MCINTOSH
Model : C53
Category : Receiver