DS-PR1-WE（O-STD） - Alarm system Hikvision - Free user manual and instructions
Find the device manual for free DS-PR1-WE（O-STD） Hikvision in PDF.
Pick your language and provide your email: we'll send you a specifically translated version.
| Product Type | Wireless PIR Motion Detector |
| Model | DS-PR1-WE (O-STD) |
| Brand | Hikvision |
| Detection Method | Passive Infrared (PIR) |
| Detection Range | Up to 12 meters (wall-mounted at 2.5m height) |
| Detection Angle | 110° horizontal |
| Wireless Protocol | Hikvision-proprietary or 433/868 MHz (check manual) |
| Frequency | 868 MHz (typical for European version) |
| Power Supply | CR123A 3V Lithium Battery (1 piece) |
| Battery Life | Up to 3 years (typical usage) |
| Operating Temperature | -10°C to +55°C |
| Operating Humidity | Up to 95% non-condensing |
| Dimensions (H x W x D) | Approx. 108 x 54 x 44 mm |
| Weight | Approx. 90 g (with battery) |
| Material | ABS plastic |
| Color | White |
| Installation | Wall or ceiling mount, height 2.0-3.0 m recommended |
| Tamper Protection | Yes (tamper switch against cover removal) |
| LED Indicator | Red LED for alarm, green for walk test |
| Compliance | CE, FCC (depending on region) |
| Warranty | 2 years (standard) |
Frequently Asked Questions - DS-PR1-WE（O-STD） Hikvision
How to install the Hikvision DS-PR1-WE detector?
Mount the detector at a height of 2.0-3.0 meters on a wall or ceiling using the included bracket. Ensure the detection area is not blocked by obstacles. Insert the CR123A battery, pair the detector with your alarm panel following the panel's instructions, and perform a walk test.
What type of battery does the DS-PR1-WE use and how long does it last?
It uses one CR123A 3V lithium battery. Battery life typically lasts up to 3 years depending on usage and environmental conditions.
What is the detection range of the DS-PR1-WE?
The detection range is up to 12 meters with a 110° horizontal angle when mounted at the recommended height of 2.5 meters.
Can the DS-PR1-WE be used outdoors?
No, this detector is designed for indoor use only. Operating temperature range is -10°C to +55°C, but it is not weatherproof.
How to pair the detector with a Hikvision alarm panel?
Put the alarm panel into pairing mode (refer to panel manual). Insert the battery in the detector, and within 60 seconds, press the tamper switch or follow the quick start guide. The panel will confirm successful pairing.
What does the red LED indicator mean?
A red LED flash indicates an alarm event (motion detected). During walk test, the LED may blink green to confirm signal transmission.
How to change the battery in the DS-PR1-WE?
Remove the cover by unscrewing the bottom screw. Take out the old CR123A battery and insert a new one with correct polarity. Replace the cover and tighten the screw. The detector will automatically resume operation.
Is the DS-PR1-WE compatible with third-party alarm systems?
The detector uses Hikvision's proprietary wireless protocol. It is primarily designed for Hikvision alarm panels. Compatibility with third-party systems is not guaranteed.
What is the tamper protection feature?
The detector has a tamper switch that triggers an alarm if the cover is forcibly removed from the mounting base, protecting against sabotage.
How to clean and maintain the detector?
Wipe the exterior with a soft, dry cloth. Do not use water or cleaning agents. Check the battery annually and replace if low. Ensure the detection window is free of dust or cobwebs.
User questions about DS-PR1-WE（O-STD） Hikvision
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
No questions yet. Be the first to ask one.
Download the instructions for your Alarm system in PDF format for free! Find your manual DS-PR1-WE（O-STD） - Hikvision and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. DS-PR1-WE（O-STD） by Hikvision.
USER MANUAL DS-PR1-WE（O-STD） Hikvision
Manual assistant
Powered by Anthropic
Waiting for your message
Product information
Brand : Hikvision
Model : DS-PR1-WE（O-STD）
Category : Alarm system