PA-250 - Sound system DAP-Audio - Free user manual and instructions
Find the device manual for free PA-250 DAP-Audio in PDF.
Pick your language and provide your email: we'll send you a specifically translated version.
| Type | Sound system / Powered mixer |
| Brand | DAP-Audio |
| Model | PA-250 |
| Power output | 250 W RMS (approximate) |
| Inputs | 2 x XLR/Jack microphone inputs, 2 x RCA line inputs |
| Outputs | 2 x Speakon speaker outputs, 1 x RCA line output |
| Built-in effects | Digital reverb and delay |
| Equalizer | 3-band EQ per channel |
| Phantom power | +48 V for condenser microphones |
| Dimensions | 483 x 270 x 89 mm (19 inch rackmount, 2U) |
| Weight | Approximately 9.5 kg |
| Power supply | AC 230 V / 50 Hz, internal power supply |
| Protection | Overload, short circuit, thermal protection |
| Cooling | Variable speed fan |
| Maintenance | Clean with a dry, lint-free cloth; avoid liquids |
| Repair | Fuse replacement only; other repairs by qualified service personnel |
| Accessories included | Power cord, user manual |
Frequently Asked Questions - PA-250 DAP-Audio
How do I connect speakers to the PA-250?
Connect your speakers to the Speakon outputs (marked SPEAKER OUT). Ensure the speaker impedance is 4-8 ohms and total load does not exceed the amplifier's rating.
Can I use condenser microphones with this mixer?
Yes, the PA-250 provides +48V phantom power on the XLR inputs. Enable it via the switch on the rear panel when using condenser mics.
What does the red CLIP LED indicate?
The CLIP LED lights when the input signal is too high, causing distortion. Reduce the channel gain or master volume to prevent clipping.
How do I apply reverb to a channel?
Each channel has a REVERB control knob. Turn it clockwise to add reverb effect. The master reverb level is set with the internal digital effects processor.
What is the maximum power output?
The PA-250 delivers approximately 250 watts RMS into 4 ohms per channel (stereo). Actual power may vary depending on load and mains voltage.
Can I connect a subwoofer?
Yes, use the LINE OUT (RCA) to connect to an active subwoofer. Alternatively, some passive subwoofers can be connected to the main speaker outputs with appropriate crossover settings.
How do I reset the amplifier after protection mode?
First, turn off the unit and check for short circuits or overheating. Wait 10 minutes, then power on again. If protection persists, reduce load or ensure proper ventilation.
Does the PA-250 have Bluetooth?
No, the PA-250 does not include Bluetooth. Use the line inputs (RCA or jack) to connect an external Bluetooth receiver.
What type of fuse does it use?
The mains fuse is a 5x20mm, T2A (time-lag, 2A) fuse. Always replace with the same type and rating.
How should I clean the unit?
Disconnect from power before cleaning. Use a soft, dry cloth. Do not use any solvents or abrasive cleaners, and avoid moisture entering the ventilation slots.
User questions about PA-250 DAP-Audio
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
No questions yet. Be the first to ask one.
Download the instructions for your Sound system in PDF format for free! Find your manual PA-250 - DAP-Audio and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. PA-250 by DAP-Audio.
USER MANUAL PA-250 DAP-Audio
Manual assistant
Powered by Anthropic
Waiting for your message
Product information
Brand : DAP-Audio
Model : PA-250
Category : Sound system