cruZer 2 2775 - Razor BRAUN - Free user manual and instructions

Product Type	Electric Foil Shaver
Brand	Braun
Model	cruZer 2 2775
Cutting System	Foil and Cutter Block
Power Source	Rechargeable Battery (Li-Ion)
Charging Time	1 hour
Usage Time	45 minutes
Voltage	100-240V Auto-Voltage
Weight	Approx. 200g
Dimensions (L x W x H)	15.0 x 6.0 x 4.0 cm
Washable	Yes, under running water
Trimmer	Precision Trimmer for sideburns and details
Drive Type	Rotary Oscillating
On/Off Switch	Slider switch with lock function
Cleaning Brush	Included
Protective Cap	Included
Repairability	Replaceable foil and cutter block
Safety Features	Rounded foil edges, skin protection guard

Frequently Asked Questions - cruZer 2 2775 BRAUN

How do I clean the Braun cruZer 2 2775 shaver?

Rinse the shaver head under running water after each use. Use the included cleaning brush to remove hair clippings. Do not use harsh chemicals.

How long does the battery last on a full charge?

A full charge provides approximately 45 minutes of cordless shaving. Charging time is about 1 hour.

Can I use the shaver while charging?

No, the Braun cruZer 2 2775 is designed to be used cordless only. Do not operate while connected to the charger.

How often should I replace the foil and cutter block?

For optimal performance, replace the foil and cutter block every 18 months or when they show signs of wear. Use genuine Braun parts.

Is the shaver waterproof?

Yes, the shaver head can be rinsed under running water. However, the body is not fully waterproof; avoid submerging.

Does it have a travel lock?

Yes, hold the on/off switch for 3 seconds to activate the travel lock, preventing accidental activation.

What type of battery does it use?

It uses a built-in Lithium-Ion rechargeable battery. The battery is not user-replaceable.

How do I charge the shaver for the first time?

Charge the shaver for at least 4 hours before first use. After that, a normal charge cycle takes about 1 hour.

Can I use shaving cream or gel?

Yes, you can use shaving cream or gel for a wet shave. Rinse the shaver head thoroughly after use.

Where can I find replacement parts?

Replacement foils and cutter blocks are available at authorized Braun dealers or online. Use model number 21B for the cruZer 2 series.

USER MANUAL cruZer 2 2775 BRAUN

Korean

Our products are designed to meet the highest standards of quality, functionality and design. We hope you entirely enjoy your new Braun shaver.

Warning

Your shaver is provided with a special cord set with an integrated Safety Extra Low Voltage power supply. Do not exchange or manipulate any part of it. Otherwise there is risk of electric shock.

Description

1 Foil protection cap

2 Shaver foil

3 Cutter block

4 Styler

4a Wide shaper (28 mm)

4b Narrow shaper (14 mm)

5 Charging light

6 On/off switch

7 Special cord set

Charging

The best environmental temperature for charging is between 15 °C and 35 °C.

• Using the special cord set, connect the shaver to an electrical outlet with the motor switched off.
• When charging for the first time, leave the shaver to charge continuously for 4 hours. The green charging light (5) shows that the shaver is being charged. When the battery is fully charged, the charging light intermittently blinks on and off. This indicates that the battery maintains its full capacity.
• A full charge provides 30 minutes of cordless shaving time depending on your beard growth.
• Once the shaver is completely charged, discharge the shaver through normal use. Then recharge to full capacity. Subsequent charges will take about 1 hour.
• Maximum battery capacity will only be reached after several charging/discharging cycles.
• If the rechargeable batteries are discharged, you may also shave by connecting the shaver to an electrical outlet via the special cord set.

Shaving

Remove the foil protection cap (1).

Activate the on/off switch (6). The floating foil frame automatically adapts to your skin surface for a close, smooth shave.

For pre-shaving after a few days of not having shaved, use the wide shaper (4a) to pre-cut long hairs. For a close, smooth shave, finish with the foil.

Tips for the perfect shave

• We recommend that you shave before washing, as the skin tends to be slightly swollen after washing.
• Hold the shaver at right angles (90°) to the skin (b). Stretch the skin and shave against the direction of beard growth.
• To maintain 100% shaving performance, replace your foil and cutter block at least every 18 months or when worn.

Using the stylist

• The wide shaper (4a) evenly cuts and trims larger areas (c): Ideal for shaping sideburns, moustaches and partial short beards. Press the blue rib to push out the styler (4).
• The narrow shaper (4b) precisely defines lines and edges (d): Ideal for precise contouring. To use the narrow shaper, push out the stylist and turn it 180 degrees.
• Frequent use of the stylist may reduce the battery capacity.

Cleaning

This appliance is suitable for cleaning under an open water tap.

Warning: Detach the hand-held part from the power supply before cleaning it in water.

Regular cleaning ensures better shaving performance.

Rinsing the shaving head after each shave under running water is an easy and fast way to keep it clean:

- Switch the shaver on (cordless) and rinse the shaving head under hot running water (e). A natural based soap may also be used provided it contains no particles or abrasive substances. Rinse off all foam and let the shaver run for a few more seconds.

- Next, switch off the shaver, remove the shaver foil and the cutter block. Then leave the disassembled shaving parts to dry.

Alternatively, you may clean the shaver using the brush provided (f):

• Switch off the shaver. Remove the shaver foil.
• Using the brush, clean the cutter block and the inner area of the shaver head. However, do not clean the shaver foil with the brush as this may damage the foil.

Keeping your shaver in top shape

About every four weeks, clean the cutter block with Braun cleaning agents. Put a drop of light machine oil onto the shapers (4a, 4b) and the shaver foil (g).

Replacing the shaving parts

To maintain 100% shaving performance, replace your foil and cutter block at least every 18 months or when worn. Change both parts at the same time for a closer shave with less skin irritation.

(Shaver foil and cutter block: 2000 series)

Preserving the batteries

In order to maintain the optimum capacity of the rechargeable batteries, the shaver has to be fully discharged (by shaving) every 6 months approximately. Then recharge the shaver to full capacity. Do not expose the shaver to temperatures higher than 50 °C for extended periods of time.

Environmental notice

This product contains rechargeable batteries. In the interest of protecting the environment, please do not dispose of the product in the household waste at the end of its useful life. Disposal can take place at a Braun Service Centre or at appropriate collection points provided in your country.

Subject to change without notice.

This product conforms to the European Directives EMC 89/336/EEC and Low Voltage 73/23/EEC.

Electric specifications see printing on the special cord set.

-

5-733-355/00/VIII-05

Korea/GB

BRAUN cruZer²

2775

Type 5733

www.braun.com/register