Small Stone - Guitar effects pedal Electro Harmonix - Free user manual and instructions

Product Type	Guitar Effects Pedal
Model	Small Stone
Brand	Electro Harmonix
Circuit Type	Analog
Effect Type	Phaser
Controls	Rate, Color Switch
Audio Connectors	1/4" Input, 1/4" Output
Power Supply	9V DC (Center Negative, 2.1mm) or 9V Battery
Current Draw	Approximately 10 mA
Dimensions (Width x Depth x Height)	70 mm x 115 mm x 50 mm
Weight	Approximately 300 g
Chassis Material	Metal
Bypass Mode	True Bypass
Indicator LED	Yes, for effect on/off
Color Switch	Selects between Normal and Deep (more intense) phasing
Frequency Range	Low to high sweep, adjustable via Rate
Usage	For electric guitar or other instruments
Warranty	1 year (check manufacturer)
Repairability	Serviceable by qualified technician
Included Accessories	None (pedal only)

Frequently Asked Questions - Small Stone Electro Harmonix

How do I connect the Small Stone pedal?

Connect your instrument to the Input jack and run a cable from the Output jack to your amplifier or next pedal. Use a standard 1/4" instrument cable.

What power supply does the Small Stone need?

It requires a 9V DC power supply with center negative polarity and a 2.1mm barrel connector. Alternatively, you can use a 9V battery.

How do I change the battery?

Remove the screws on the bottom plate to access the battery compartment. Insert a fresh 9V battery, observing polarity, and replace the plate.

What does the Color switch do?

The Color switch selects between two phaser modes: Normal gives a subtle, classic phase shift; Deep provides a more intense and pronounced effect.

Why is my pedal not turning on?

Check if the power supply is connected and functioning, or if the battery is fresh. Also ensure the input cable is plugged in securely. The LED should light up when the pedal is active.

Can I use the Small Stone with keyboards or other instruments?

Yes, it works with any instrument with a 1/4" jack output. However, line-level instruments may cause distortion; adjust your levels accordingly.

How do I clean the pedal?

Use a dry or slightly damp cloth to wipe the exterior. Avoid solvents. Keep the jacks and switches free of dust.

Is the Small Stone true bypass?

Yes, when the effect is off, the signal goes through true bypass, maintaining your guitar's tone without coloration.

What is the current draw of the Small Stone?

It draws approximately 10 mA, making it compatible with most pedalboard power supplies.

Can I daisy chain the Small Stone with other pedals?

Yes, as long as the total current draw does not exceed your power supply's capacity. The low current draw makes it easy to daisy chain.

USER MANUAL Small Stone Electro Harmonix

Congratulations on your purchase of the Electro-Harmonix Nano Stone! The Nano Stone is identical to the Electro-Harmonix Small Stone, just smaller. The Small Stone was first manufactured back in the early 70's making it one of the first compact phase shifters on the market. To this day, the Small Stone is still the pedal to use when musicians want a fat, warm analog phase shifter.

- OPERATING INSTRUCTIONS -

Connect your instrument to the INPUT jack. Connect your amplifier to the AMP jack. Please note that whenever a plug is inserted into the INPUT jack, the Nano Stone is ON and it is draining current from the battery.

The STATUS LED will light up when the Nano Stone is in effect mode. When in True Bypass mode, the LED will be off. Use the FOOTSWITCH to toggle between effect and True Bypass mode.

The RATE control adjusts the speed of the phasing sweep, turn RATE clockwise for a faster sweep.

The COLOR Switch changes the sound of the phase shift between a full and robust phase shift in the DOWN position to a more pronounced instance phase shift in the UP position. When in the UP position, notice how the Nano Stone carves into the frequency spectrum hollowing out the sound.

Fundamentals and harmonics glide in and out for an extremely pronounced shifting effect. Return the COLOR switch to the down position and notice the fullness.

- POWER -

Power from the internal 9-volt battery is activated by plugging into the INPUT jack. The input cable should be removed when the unit is not in use to avoid running down the battery. If a battery eliminator is used, the Nano Stone will be powered up as long as a wall-wart is plugged into the wall.

The barrel connector on the front of the Nano Stone is for a 9-volt battery eliminator capable of delivering 100 mA of current. The inner ring of the 9-volt battery eliminator must be negative, the outer ring positive. The unit's battery may be left in or taken out when the eliminator is in use.

To change the 9-volt battery, you must remove the 4 screws on the bottom of the Nano Stone. Once the screws are removed, you can take off the bottom plate and change the battery. Please do not touch the circuit board while the bottom plate is off or you risk damaging a component.

The input impedance presented at the Input Jack is 100 k-ohms. The output impedance at the Output Jack is 15 k-ohms.

- WARRANTY INFORMATION -

Please register online at http://www.ehx.com/product-registration or complete and return the enclosed warranty card within 10 days of purchase. Electro-Harmonix will repair or replace, at its discretion, a product that fails to operate due to defects in materials or workmanship for a period of one year from date of purchase. This applies only to original purchasers who have bought their product from an authorized Electro-Harmonix retailer. Repaired or replaced units will then be warranted for the unexpired portion of the original warranty term.

If you should need to return your unit for service within the warranty period, please contact the appropriate office listed below. Customers outside the regions listed below, please contact EHX Customer Service for information on warranty repairs at [e-mail] or [phone]. USA and Canadian customers: please obtain a Return Authorization Number (RA#) from EHX Customer Service before returning your product. Include with your returned unit: a written description of the problem as well as your name, address, telephone number, e-mail address, and RA#; and a copy of your receipt clearly showing the purchase date.

United States & Canada

EHX CUSTOMER SERVICE

ELECTRO-HARMONIX

c/o NEW SENSOR CORP.

47-50 33RD STREET

LONG ISLAND CITY, NY 11101

Tel: [phone]

Email: [e-mail]

Europe

JOHN WILLIAMS

ELECTRO-HARMONIX UK

13 CWMDONKIN TERRACE

SWANSEA SA2 0RQ

UNITED KINGDOM

Tel: [phone]

Email: [e-mail]

This warranty gives a purchaser specific legal rights. A purchaser may have even greater rights depending upon the laws of the jurisdiction within which the product was purchased.

To hear demos on all EHX pedals visit us on the web at www.ehx.com

Email us at [e-mail]