Avent SCF474 - Baby product PHILIPS - Free user manual and instructions

USER MANUAL Avent SCF474 PHILIPS

Register your product and get support at www.philips.com/welcome

www.philips.com/event Philips Consumer Lifestyle BV Tussenstepan 4, 9206 AD Drachter, Netherlands Trademarks owned by the Philips Group. 6.2017 Kostinklijke Philips N.V. All rights reserved

Diagram illustrating a spray bottle being dispensed with a spray can, showing the process from top to bottom.

Diagram showing a multi-step food preparation or cleaning process with labeled containers and steps

ENGLISH

Important

For your child's safety and health

WARNING!

-Always use this product with adult supervision.
- Never use feeding teats as a soother.
-Continuous and prolonged sucking of fluids will cause tooth decay.
-Always check food temperature before feeding
-Heating in a microwave oven may produce localised high temperatures. Take extra care when you heat up drinks in a microwave.

-Keep all parts not in use out of the reach of children.

-Do not allow child to play with small parts or walk/run while using bottles or cups.

-Do not place in a heated oven.

-Drinks other than milk and water, such as fruit juices and flavoured sugary drinks are not recommended. If they are used, they should be well diluted and only used for limited periods, not constantly sipped.

- Do not use abrasive cleaning agents or antibacterial cleaners. Do not place components directly on surfaces that have been cleaned with anti-bacterial cleaners.

-Expressed breast milk can be stored in sterilized Philips Avent bottles/containers in the refrigerator for up to 48 hours (not in the door) or in the freezer for up to 3 months. Never refreeze breast milk or add fresh breast milk to already frozen milk
-Always discard any breast milk that is left over at the end of a feed.
-Plastic material properties may be affected by sterilizing and high temperatures. This can affect the fit of the cap.
-Throw away any part at the first signs of damage or weakness.
-Do not alter the product or parts of it in any way. This may result in unsafe functioning of the product.

Teat

-Inspect before each use and pull the feeding teat in all directions. Throw away at the first signs of damage or weakness.
-For hygiene reasons, we recommend replacing teats after 3 months
-Keep teats in a dry, covered container.
- Do not leave a feeding teat in direct sunlight or heat, or leave in disinfectant.

Before first use

-Before first use, disassemble all parts, clean and sterilise the product.
-Clean to ensure hygiene by washing and rinsing all parts thoroughly.

-Sterilise by using a Philips Avent sterilizer or boil all parts for 5 minutes. This is to ensure hygiene.
-During sterilising with boiling water, prevent the bottle or other parts from touching the side of the pan. This can cause irreversible product deformation or damage that Philips cannot be held liable for.
-When using microwave sterilisator set to max 1000 Watt and follow user instructions of the sterilizer precisely.
-Inspect the feeding teat before use and pull the feeding teat in all directions. Do not use damaged products.
-After every use, take all items apart, wash in warm soapy water and rinse thoroughly. Make sure that you wash your hands thoroughly and that the surfaces are clean before contact with sterilised components.
-Excessive combinations of detergents may eventually cause plastic components to crack. Should this occur, replace immediately.
-Dishwasher safe. Food colorings may discolor components.
-When not in use, do not store in sunlight or heat, or leave in disinfectant (‘sterilizing solution’) for longer than recommended, as this may weaken the teat. Do not place in a heated oven.
-Clean and sterilize all parts before each use.

Cleaning

Assembly

When you assemble the bottle, make sure you place the cap vertically onto the bottle so that the teat sits upright (see image for more details). To remove the cap, place your hand over the cap and your thumb in the dimple of the cap. The teat is easier to assemble if you wriggle it upwards instead of pulling it up in a straight line. Make sure you pull the teat through until its lower part is even with the screw ring

Maintenance

-Before each use, inspect all items. Pull the feeding teat in all directions.

-Throw away any part at the first signs of damage or weakness.

-For hygiene reasons, we recommend replacing teats after 3 months.

-Keep teats in a dry, covered container.

-When not in use, do not leave in sunlight or heat, or leave in disinfectant (‘sterilising solution’) for longer than recommended, as this may weaken the teat. Do not place in a heated oven.

Choosing the right teat for your baby

The Philips Avent teats are available with different flow rates to help your baby with drinking. Over time you can change the teat accommodating the individual needs of your baby. Philips Avent teats are clearly numbered on the side to indicate flow rate (see image). Make sure you use a teat with the correct flow rate when you feed your baby. Use a lower flow rate if your baby chokes, is leaking milk or has trouble adjusting to the drinking speed. Use a higher flow rate if your baby falls asleep during feeding, gets frustrated or when feeding takes a very long time. Teats are available for 0m, 0m+, 1m+, 3m+, 6m+, variable flow (I/II/III) and thick feed (Y).

(0) The teat for Om can be used from day one. Extra soft silicone teat and it is the lowest flow rate available. Ideal for newborn and breastfed babies of all ages. The teat only has one opening for fluids and the number 0 is shown on the teat.

(1) The teat for 0m+ has an extra soft silicone teat. Ideal for newborn and breastfed babies of all ages. The teat has only one opening for fluid and the number 1 is shown on the teat.

(2) The teat for 1m+ has an extra soft silicone teat. Ideal for breastfed babies of all ages. The teat has two openings for fluid and the number 2 is shown on the teat.

(3) The teat for 3m+ has an extra soft silicone teat. For bottle fed babies at 3 months of age and up. The teat has three openings for fluid and the number 3 is shown on the teat.

(4) The teat for 6m+ has a bite resistant silicone teat. The sturdier teat is ideal for bottle fed babies at 4 months of age and up. The teat has four openings for fluid and the number 4 is shown on the teat.

(I/II/III) Variable flow: has a bite resistant silicone teat. The sturdier teat, with an adjustable flow rate

to babies convenience is ideal for bottle fed babies at 3 months of age and up. The teat has one slot cut on the top for fluid and the markings I, II, III on the edges of the teat.

(Y) Thick feed: has a bite resistant silicone teat. The sturdier teat, designed for thicker feeds is ideal for bottle fed babies at 6 months of age and up. The teat has one Y cut for fluid and the symbol Y on the teat.

Note: Every baby is unique and your baby's individual needs may vary from the description of flow rates.

Ordering accessories

To buy accessories or spare parts, visit www.shop.philips.com/service or go to your Philips dealer. You can also contact the Philips Consumer Care Center in your country (see the international warranty leaflet for contact details).

Compatibility

-Spare teats are available separately. Make sure you use a teat with the correct flow rate when you feed your baby. To buy accessories or spare parts, visit www.shop.philips.com/service or go to your Philips dealer. You can also contact the Philips Consumer Care Centre in your country.

- When you use an Philips Avent sterilizer, please check on the website how to place the Natural bottle.

-The high quality plastic Natural bottle is compatible with most Philips Avent breast pumps, spouts, sealing discs and cup tops

-The glass Natural bottle is compatible with Philips Avent breast pumps and sealing discs. For safety reasons, it is not recommended to use glass Natural bottles with handles, spouts and cup tops and spouts. If the bottle falls, it may break. -For more information about the materials used for Philips bottles: www.philips.com/avent/materials

简体中文

注意事项

为了儿童的安全和健康

警告！

-务必在成人的监督下使用本产品。

-请勿将奶嘴用作安抚奶嘴。

- 长时间持续吮吸液体将导致产生驻牙。

-喂食前请务必检查食物的温度。

- 在微波炉中加热可能会产生局部高温。

在微波炉中加热饮料时应格外小心。