HRP-600-5 - Switching Power Supply Mean Well - Free user manual and instructions

Product Type	Single Output Switching Power Supply
Brand	Mean Well
Model	HRP-600-5
Output Voltage	5 VDC
Output Current	120 A
Output Power	600 W
Input Voltage	115 / 230 VAC (switch selectable)
Input Frequency	47 - 63 Hz
Efficiency	Typ. 85%
Dimensions (L x W x H)	240 x 124 x 65 mm
Weight	1.5 kg
Cooling	Built-in DC fan
Operating Temperature	-20°C to +70°C (derating above 50°C)
Protection Features	Short circuit, overload, overvoltage, over temperature
Safety Certifications	UL 60950-1, CB, CE, TUV
Remote ON/OFF Control	Available (optional)
Warranty	3 years

Frequently Asked Questions - HRP-600-5 Mean Well

What is the output voltage and current of the HRP-600-5?

The output voltage is 5 VDC and the output current is 120 A, providing a total power of 600 W.

What input voltage does the HRP-600-5 accept?

It accepts 115 VAC or 230 VAC via a selector switch, with a frequency range of 47-63 Hz.

Does the HRP-600-5 have remote sense capability?

Yes, it includes remote sense terminals to compensate for voltage drops in load wires, ensuring accurate output voltage at the load.

What protections does the HRP-600-5 have?

It features short circuit, overload, overvoltage, and over temperature protection with auto-recovery.

How should I connect the AC input?

Connect the AC input to the terminal block: L (Live), N (Neutral), and FG (Frame Ground). Ensure the input voltage selector matches your line voltage.

What is the operating temperature range?

The operating temperature range is -20°C to +70°C, with output derating above 50°C. Ensure adequate ventilation.

Does the power supply require a fan?

Yes, it has a built-in DC fan for forced air cooling. Keep the fan intake and exhaust unobstructed.

What are the dimensions and weight?

Dimensions are 240 x 124 x 65 mm (9.45 x 4.88 x 2.56 inches) and weight is approximately 1.5 kg (3.3 lbs).

Can I adjust the output voltage?

Yes, the output voltage can be adjusted via a built-in potentiometer within a range of ±10% of the nominal voltage.

Is the HRP-600-5 certified for safety?

Yes, it is certified to UL 60950-1, CB, CE, and TUV standards.

USER MANUAL HRP-600-5 Mean Well

● Type : Enclosed Type Switching Power Supply

(Families: G3, NE, LRS, SE, PFC, HSP, SPV, USP, RST, G5, MSP)

- Introduction

Enclosed type switching power supplies possess a metal or plastic case for covering their internal PCB and will be installed inside the case of the end system. Mean Well's enclosed type power supplies include 2 different groups of power supplies, with built-in fan and without built-in fan, depending on their rated power or design concept.

- Installation

(1) Before any installation or maintenance work, please disconnect your system from the utility. Ensure that it can't be re-connected inadvertently!
(2) Keep enough insulation distance between mounting screws and internal components of power supplies. Please refer to case drawing on specifications to receive the maximum length of mounting screw.
(3) Mounting orientations other than standard orientation or operate under high ambient temperature may increase the internal component temperature and will require a de-rating in output current. Please refer to the specification sheets to receive the optimum mounting position and information about the de-rating curve.
(4) Fans and ventilation holes must be kept free from any obstructions. Also a 10-15 cm clearance must be kept when the adjacent device is a heat source.
( 5 ) Input and Output terminal

Series\Terminal Screw	Screw Size	Suggested Torque
RSP-750 / 1000 / 1500 / 2000 / 2400 / 3000SE-450 / 1000 / 1500HEP-600 · HRP-300 · HRPG-300 · MSP-300SP-480 · SP-750 · SPV-1500 · USP-500 · RST-10000	M4	10-12kgf-cm
HRP-075 / 100 / 150 / 200 · HRPG-150 / 200LRS-035 / 050 / 075 / 100 / 150 / 150F / 200 / 350MSP-100 / 200NED-035 / 050 / 075 / 100 · NET-035 / 050 / 075NES-025 / 035 / 050 / 075 / 100 / 150 / 200 / 350QP-200 / 320 / 375RD-050 / 065 / 085 / 125 · RID-050 / 065 / 085 / 125RS-035 / 050 / 075 / 100 / 150RSP-075 / 100 / 150 / 200 / 320SP-075 / 100 / 150 / 200 / 240 / 320 · SPV-150/300SE-100 / 200 / 350 · HSP-250 · PSP-600	M3.5	8-10 kgf-cm
RSP-1600RD-035 · RT-050 / 065 / 085 / 125RQ-050 / 065 / 085 / 125TP-075 / 100 / 150 · QP-100 / 150RS-015 / 025NES-015 · USP-150	M3	6-8 kgf-cm
ERP-350HDP-190 / 240NEL-200 / 300	#6	8-10 kgf-cm

Installation Manual

Series\Terminal Screw	Input		Output
	Screw Size	Suggested Torque	Screw Size	Suggested Torque
HRP-450 / 600HRPG-450 / 600MSP-450 / 600SE-600	M3	6-8kgf-cm	M4	10-12kgf-cm
HSP-150 / 200 /300HSN-200 / 300	M3	6-8kgf-cm	M3.5	8-10kgf-cm
RSP-500	M3.5		8-10kgf-cm
RST-5000	M4		10-12kgf-cm M8 10-12kgf-cm
NEL-400	#6		8-10kgf-cm

(6) Recommended wires are shown as below.

AWG	18		16	14		12
Rated Current of Equipment (Amp)	6A	6-10A	10-16A	16-25A	25-32A	32-40A
Cross-section of Lead( mm2 )	0.75	1.00	1.5	2.5	4	6
Note: Current each wire carries should be de-rated to 80% of the current suggested above when using 5 or more wires connected to the unit.

10

Make sure that all strands of each stranded wire enter the terminal connection and the screw terminals are securely fixed to prevent poor contact.

(7) For other information about the products, please refer to www.meanwell.com for details.

● Warning / Caution !!

(1) Risk of electrical shock and energy hazard. All failure should be examined by a qualified technician. Please do not remove the case of the power supply by yourself!
(2) Please do not install power supplies in places with high moisture or near the water.
(3) Please do not install power supplies in places with high ambient temperature or near fire source. The maximum ambient temperature please refer to their specifications.
(4) Output current and output wattage must not exceed the rated values on specifications.
(5) The ground(FG) must be connected to earth ground.
(6) All MW's PSUs are designed in accordance with EMC regulations and the related test reports are available by request. Since they are belong to component power supplies and will be installed inside system enclosure, when they are integrated into a system, the EMC characteristics of the end system must be re-verified again.

Manufacturer :

MEAN WELL ENTERPRISES Co., LTD.

No.28, Wuquan 3rd Rd., Wugu Dist.,

New Taipei City 24891, Taiwan

Tel: [phone]

Web: www.meanwell.com

Branch Office :

China

MEAN WELL (GUANGZHOU)

ENTERPRISES Co., LTD.

2F, A Building, Yuean Industry Park,

Huangcun, Dongpu Yown, Tianhe

District, Gungzhou, China

Post Code:510660

Tel: [phone]

Web: www.meanwell.com.cn

U.S.A.

MEAN WELL USA, INC.

44030 Fremont Blvd., Fremont,

CA 94538, U.S.A.

Tel: [phone]

Web: www.meanwellusa.com

Europe

MEAN WELL EUROPE B.V.

Langs de Werf 8, 1185XT

Amstelveen, The Netherlands

Tel: [phone]

Web: www.meanwell.eu

Declaration of China RoHS Conformity

In order to reduce the impacts on the environment and take the more responsibility for protecting the earth, MEAN WELL is confirming and announcing the conformity to China RoHS, an Administrative Measures for the Restriction of the Use of Hazardous Substances in Electrical and Electronic Products.

Environment Friendly Use Period Label

	Observing SJT 11364-2014, Marking for the Restricted Use of Hazardous Substances in Electronic and Electrical Products
	Observing SJ/Z 11388-2009, General Guidelines of Environment-friendly Use Period of Electronic Information Products Appendix B, adopting table look-up to verify the Environment Friendly Use Period

Names and Contents of Hazardous Substances Lists

Part Name	Hazardous Substances
	Lead(Pb)	Mercury(Hg)	Cadmium(Cd)	Hexavalent chromium( Cr6+ )	Polybrominated biphenyls(PBB)	Polybrominated diphenyl ethers(PBDE)
PCB and its components	X	O	X	O	O	O
Metal structure parts	X	O	O	O	O	O
Plastic structure parts	O	O	O	O	O	O
Accessories	O	O	O	O	O	O
Cables	X	O	O	O	O	O
O: The concentration of the hazardous substances within the homogeneous material of that product is less than the concentration limits set by GB/T 26572-2011.X: The concentration of the hazardous substances within the homogeneous material of that product is over the concentration limits set by GB/T 26572-2011; however, it follows the standard advised by 2011/65/EU.