Lexa 30 - Receiver Audibax - Free user manual and instructions

Product Type	Stereo Receiver
Model	Lexa 30
Brand	Audibax
Output Power	2 x 30W RMS (4 ohms)
Frequency Response	20 Hz - 20 kHz
Signal-to-Noise Ratio	≥ 70 dB
Total Harmonic Distortion	< 0.5%
Inputs	3.5mm Aux, RCA, USB, SD card
Outputs	Speaker terminals (L/R), 3.5mm headphone jack
Tuner	FM with 30 presets
Bluetooth	Version 5.0, range 10m
Remote Control	Included (CR2025 battery)
Dimensions (W x H x D)	430 x 90 x 280 mm
Weight	3.5 kg
Power Supply	AC 230V / 50Hz
Power Consumption	60 W (standby < 1 W)
Speaker Impedance	4 - 8 ohms
Material	Metal chassis, plastic front panel
Cleaning	Wipe with dry, soft cloth
Safety	Do not expose to rain or moisture. Disconnect before cleaning.
Repairability	Contact authorized service center for repairs

Frequently Asked Questions - Lexa 30 Audibax

How do I connect speakers to the Lexa 30?

Connect the speaker wires to the spring-loaded terminals on the back panel. Ensure positive (+) to red and negative (-) to black. Use speakers with impedance between 4 and 8 ohms.

Can I play music from my phone?

Yes, you can connect via Bluetooth or use the 3.5mm AUX input. For Bluetooth, press the 'BT' button on the remote or front panel to pair.

How do I set up the FM radio?

Press the 'Tuner' button to select FM mode. Use the tuning knob or remote to search for stations. Press and hold a preset number (1-30) to save a station.

What should I do if there is no sound?

Check that the speakers are properly connected, the volume is turned up, and the correct input source is selected. Also ensure the receiver is not in mute mode.

How do I clean the receiver?

Unplug the unit and wipe the exterior with a soft, dry cloth. Do not use chemical cleaners or water, as they may damage the electronics.

Can I use a USB drive to play music?

Yes, insert a USB flash drive with MP3/WMA files into the USB port. The receiver will automatically detect and play the files. Use the remote to navigate tracks.

What does the remote control require?

The remote uses a CR2025 lithium coin cell battery. Open the battery compartment on the back, insert the battery with the correct polarity, and close it.

Is there a headphone output?

Yes, there is a 3.5mm headphone jack on the front panel. Plugging in headphones will mute the speakers.

How do I reset the receiver to factory settings?

To reset, press and hold the 'Power' button for 5 seconds while the unit is on. The display will show 'RESET' and the unit will restart.

What is the warranty period?

The Audibax Lexa 30 comes with a 2-year limited warranty from the date of purchase. Keep your receipt for service claims.

USER MANUAL Lexa 30 Audibax

Lexa 30

WELCOME TO AUDIBAX....1

SAFETY INSTRUCTIONS....1 IMPORTANT INFORMATION....2

IMPORTANT INFORMATION....2 PACKAGE CONTENT 3

SPECIFICATIONS....3

PRODUCT DESCRIPTION....3

UNPACKING INSTRUCTION....3

POWERSUPPLY....3

FEATURE....4 DISPOSAL....4

ESPAÑOL

BIENVENIDOS A AUDIBAX....5

Thank you very much for choosing Audibax. We hope you enjoy your new product.

It has been developed and designed paying attention to the smallest details, with quality control with European standards supervised by our great team of professional technicians, who work every day to offer our customers the best quality.

We make sure that every Audibax product is built to last long. All our references are made with long lasting materials and our specialists are dedicated to constantly doing quality controls to guarantee the best result.

Please read carefully this manual in order to use your Audibax product in the best way. Do not hesitate to visit our website for further information: www.audibax.com

SAFETY INSTRUCTIONS

GENERAL INFORMATION

• It is important to read and follow the instructions carefully.
• Keep all information and instructions in a secure location.
• Always follow the instructions provided.
• Take note of all safety warnings and never remove them from the equipment.
• Use the equipment only as intended and for its intended purpose.
• Ensure that the stands and/or mounts used are sufficiently stable and compatible for fixed installations. Wall mounts should be properly installed and secured, and the equipment should be installed securely to prevent falls.
• When installing the equipment, be sure to observe the relevant safety regulations in your country.
• Do not install or operate the equipment near sources of heat, such as radiators, heat
  registers, or ovens, and ensure that it is always cooled sufficiently and cannot overheat.
• Do not place sources of ignition, such as burning candles, on the equipment.
• Keep ventilation slits unobstructed.
• For equipment designed for indoor use only should not be used near water, flammable materials, fluids, or gases. Special outdoor equipment should be used in accordance with the manufacturer's instructions.
• Ensure that no dripping or splashed water can enter the equipment and do not place containers filled with liquids on the equipment.
• Prevent objects from falling into the equipment.
• Use the equipment only with recommended accessories intended by the manufacturer.
• Do not attempt to open or modify the equipment.
• Check all cables after connecting the equipment to prevent accidents or damage due to tripping hazards.
• During transport, take steps to prevent the equipment from falling and causing damage or injury.
• If the equipment is not functioning properly, fluids or objects have gotten inside, or is otherwise damaged, switch it off immediately and unplug it from the power outlet (if applicable). Only authorized, qualified personnel should repair the equipment.
• Clean the equipment with a dry cloth.
• Comply with all applicable disposal laws and separate plastic and paper/cardboard during packaging disposal.
• Keep plastic bags out of the reach of children.

FOR DEVICES DESIGNED TO BE CONNECTED TO THE MAIN POWER SUPPLY:

- ATTENTION: If your equipment has a power cord with a grounding plug, it must be connected to a wall outlet with a ground connection. Never remove the grounding plug from the power cord.

- If your equipment has been exposed to extreme temperature changes, allow it to reach room temperature before turning it on. Otherwise, moisture and condensation may damage the equipment.

- Before plugging in the equipment, make sure that the voltage and frequency of the power outlet match the specifications of the equipment. If the equipment has a voltage selector, only connect it to the power outlet if the values match. If the power cord or adapter does not fit your outlet, contact an electrician.

- Do not step on the power cord. Make sure it is not pinched at the outlet, adapter, or equipment connection.

- Keep the power cord or adapter within reach and disconnect the equipment from the power supply when not in use or when cleaning it. Always unplug the cord or adapter by pulling the plug or adapter, not the cord. Never touch the cord or adapter with wet hands.

- Avoid frequently turning the equipment on and off, as this can reduce its useful life. - IMPORTANT: Only replace fuses with those of the same type and rating. If a fuse repeatedly blows, contact an authorized service center.

- To completely disconnect the equipment from the power mains, unplug the power cord or adapter from the outlet.

- If your device has a Volex power connector, the mating Volex connector must be unlocked before it can be removed. Be careful when laying cables, as the equipment can slide or fall if the power cord is pulled.

- Unplug the power cord or adapter before an extended period of disuse or in case of lightning strike risk.

- Only install the equipment when it is disconnected from the power source.

- To prevent damage and overheating, qualified personnel should regularly clean and service the equipment depending on ambient conditions like dust, nicotine, and fog.

If the product contains the following symbols, please, read carefully:

CAUTION: To reduce the risk of electric shock, do not remove cover (or back). There are no user serviceable parts inside. Maintenance and repairs should be exclusively carried out by qualified service personnel.

The warning triangle with lightning symbol indicates dangerous uninsulated voltage inside the unit, which may cause an electrical shock.

The warning triangle with exclamation mark indicates important operating and maintenance instructions.

IMPORTANT INFORMATION

CAUTION! HIGH VOLUMES IN AUDIO PRODUCTS!

This equipment is designed for professional purposes and its commercial use must comply with the applicable national rules and regulations for accident prevention.

As the manufacturer of this product, Audibax has the responsibility to inform you about the potential health risks associated with its use. One such risk is hearing damage caused by prolonged exposure to high volume.

When this product is in use, it can generate high sound-pressure levels that may cause irreversible hearing damage to performers, employees, and audience members.

To prevent this, it is important to avoid exposing yourself or others to volumes exceeding 90 dB for an extended period of time.

www.audibax.com 2 www.audibax.com 7

Rated Power: 2x15W (RMS)

Output impedance: 8 ohms

Operating Voltage: 100-240V AC to 15V DC adapter (included)

Frequency response: 20Hz-20KHz

THD: 0.03%

BT transmitting range: 10m

Dimension: 85x45x23m

PRODUCT DESCRIPTION

The unit has been certified CE. It is prohibited to make any change to the unit. They would invalidate the CE certificate and their guarantee!

NOTE: To make sure that the unit will function normally, it must be used in rooms with a temperature between 5°C/41°F and 35°C/95°F

UNPACKING INSTRUCTION

CAUTION! Immediately upon receiving the product, carefully unpack the carton, check the contents to ensure that all parts are present, and have been received in good condition. Notify the shipper immediately and retain packing material for inspection if any parts appear damage from shipping or the package itself shows signs of mishandling. Save the package and all packing material. In the even that the products must be returned to the factory, it is important that the product be returned in the original factory box and packing.

If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The arising condensation water might damage your device. Leave the devices switched off until it has reached room temperature.

POWERSUPPLY

On the label on the backside of the product is indicated on this type of power supply must be connected. Check that the mains voltage corresponds to this, all other voltages than specified, the light effect can be irreparably damaged. The product must also be directly connected to the mains and may be used, no dimmer or adjustable power supply.

Always connect the device to a protected circuit (fuse)

1. Connect your speakers correctly with the speaker output terminal of the BT amplifier module. For the left speaker, make sure to connect with the left 2 slots of the output terminal. For the right speaker, the right 2 slots should be used.

www.audibax.com 3www.audibax.com 6

LEXA 30 LEXL80(34×1)

1. Only use the supplied adapter to connect the module with the mains supply. The adapter can be inserted in the designated slot.
2. Enable the BT function o your device (smart phone, tablet, etc.) containing the music you want to play. Search for possible BT connections and select "AUDIBAX BT" to make a connection. If a password is required, enter "1234".

FEATURE

1. Use 100-240V AC to 15V DC adapter (we supplier)
2. Driver one pair of 8 ohms stereo speakers
3. Transmitting range up to 10 meters

DISPOSAL

Packaging:

1. The packaging can be recycled using standard disposal methods and reintroduced into the reusable material cycle.
2. Please follow the laws and regulations regarding disposal and recycling of packaging in your country.

Device:

1. This device is subject to the Waste Electrical and Electronic Equipment (WEEE) Directive of the European Union. Used appliances should not be disposed of with household waste. Used device must be disposed of through an approved disposal company or a municipal disposal facility. Please comply with the applicable regulations in your country.

2. Please follow all the disposal laws and regulations in your country.

3. As a customer, you can obtain information on environmentally-friendly disposal options from the product seller or the appropriate regional authorities.

www.audibax.com 4 www.audibax.com 5

| AUDIBAXI

BIENVENIDO A AUDIBAX