SW351-WLA - Flood detector SWANN - Free user manual and instructions

Product Type	Anti-Flood Alarm
Brand	Swann
Model	SW351-WLA
Power Source	2 x Alkaline AAA Batteries (3V DC)
Siren Volume	> 110dB
Siren Duration	Continuous
Siren Power Consumption	< 80mA
Battery Replacement Interval	Every 6 months
Testing Frequency	Every 1-2 months and after battery change
Sensor Type	Water sensor with two electrodes on a water-resistant cable
Installation Method	Wall-mounted with double-sided tape; sensor can be fixed with tape or glue
Indoor/Outdoor Use	Indoor use only
Usage Scenarios	Basement flooding, laundry overflow, sink or bathtub overfill
Operating Environment	Avoid direct sunlight and sudden shocks
Warranty Period	1 year from original purchase date
Technical Support Email	[e-mail]
Technical Support Phone (USA)	1-800-627-2799
Technical Support Phone (Australia)	1300 138 324
Technical Support Phone (New Zealand)	0800 479 266
Technical Support Phone (UK)	0203 027 0979

Frequently Asked Questions - SW351-WLA SWANN

How does the Swann SW351-WLA anti-flood alarm work?

The alarm uses a water sensor with two electrodes. When water bridges the electrodes, conductivity increases, triggering the siren (over 110dB). The sensor does not need full immersion; even moisture can trigger it.

How do I install the Swann SW351-WLA?

Affix the alarm unit to the wall using the provided double-sided tape. Let the sensor hang at the desired water detection level. You can also fix the sensor with tape or glue, ensuring both electrodes are exposed so water can bridge them.

How often should I replace the batteries?

Replace the alkaline AAA batteries every six months to ensure reliable operation. Use only alkaline batteries.

How do I test the alarm?

Test the alarm every 1-2 months and each time you change the batteries. To test, briefly wet the sensor electrodes with water to ensure the siren sounds.

Can I use the Swann SW351-WLA outdoors?

No, the alarm unit is for indoor use only. Do not install it outdoors. The sensor can be placed under cover but should be sheltered from direct rain.

What is the siren volume and duration?

The siren volume is greater than 110dB and sounds continuously once triggered until the sensor is dried or the batteries are removed.

What kind of batteries does it use?

It uses 2 x Alkaline AAA batteries providing 3V DC. Do not use rechargeable batteries.

How long is the warranty?

Swann warrants the product against defects in workmanship and material for one year from the original purchase date. You must present your receipt for warranty validation.

What should I do if the alarm doesn't sound when wet?

Check the batteries; replace them every six months. Ensure both electrodes are clean and exposed. Test the unit by wetting the sensor. If still not working, contact Swann Technical Support.

Can the sensor trigger from moisture or metal contact?

Yes, the sensor can be triggered by moisture (rain, humid environments) or contact with conductive materials like metal. Mount the sensor in a sheltered location to avoid false alarms.

USER MANUAL SW351-WLA SWANN

White medical device with attached plug and circular body, no visible text or symbols

Operating Instructions

About

- Do not expose any part of the alarm unit to any sudden shocks (such as being dropped or struck).

Do not• install any the alarm unit in direct sunlight.

Use only alkaline batteries.

- The alarm unit is for indoor use only. Do not install the alarm unit itself outdoors.

Replace the batteries in the unit every six months.

• Test the alarm periodically (every 1 - 2 months and each time you change the batteries) to ensure it is working properly.
• Keep this operating instruction booklet in a safe place.

Technical Specifications

Power Requirements	2 x Alkaline AAA Batteries (3V DC)
Siren Volume	>110dB
Siren Duration	Continuous
Siren Power Consumption	<80mA

Installing and Operating the Alarm Unit

Congratulations on your purchase of this anti-flood alarm from Swann! Once you've got the alarm installed, it will provide you with advanced warning of flooding, spillage, or any other water-based incident, giving you more time to react in an emergency, and more piece of mind in the mean time.

Some examples of how this alarm could be used include:

Monitoring a basement for flooding•

Detecting overflow in a laundry, bathroom or similar environment

Warning when a sink or bathtub is about to overfill•

Installation:

The alarm will sound when the sensor is exposed to water, so you should place the sensor at the level the water will be when you want the alarm to sound. Typically, this will be just above the level of the floor, but this depends on your needs.

Affix the alarm unit to the wall, using the double-sided tape provided and 1. simply let the sensor hang down to the level you want the alarm to be sensitive to.

If there is an exact level of water you want to detect, you can fix the sensor in 2. place using tape, glue or any other method you wish. Be sure to leave both electrodes exposed - if water can't make contact with them both at the same time then the alarm will not function.

How it works:

The water sensor consists of two small electrodes, mounted on a water resistant cable. These two electrodes on the sensor will detect the small increase in conductivity which occurs if they are exposed to water.

The electrodes use a very low current, and are harmless.

Remember that the sensor doesn't need to be fully immersed in water to be triggered. Simply being sufficiently wet (such as being exposed to rain or particularly moist environments) can provide enough conductivity to trigger the sensor, as can the electrodes touching metal or other conductive materials.

We suggest, therefore, that mounting the sensor somewhere under cover (or at least somewhat sheltered) is the most practicable option. Places such as a basement or underneath floorboards can be a good option, as the alarm will notify you before your home floods!

Helpdesk / Technical Support Details

Swann Technical Support

All Countries E-mail: [e-mail]

Telephone Helpdesk

USA toll free

1-800-627-2799

(Su, 2pm-10pm US PT)

(M-Th, 6am-10pm US PT)

(F 6am-2pm US PT)

USA Exchange & Repairs

I-800-627-2799 (Option I)

(M-F, 9am-5pm US PT)

AUSTRALIA toll free

1300 138 324

(M 9am-5pm AUS ET)

(Tu-F I am-5pm AUS ET)

(Sa I am-9am AUS ET)

NEW ZEALAND toll free

0800 479 266

UK

0203 027 0979

See http://www.worldtimeserver.com for information on time zones and the current time in Melbourne, Australia compared to your local time.

Warranty Information

Swann Communications USA Inc.

12636 Clark Street

Santa Fe Springs CA 90670

USA

Swann Communications

Unit 13, 331 Ingles Street,

Port Melbourne Vic 3207

Swann Communications LTD.

Stag Gates House

63/64 The Avenue

SO171XS

United Kingdom

Swann Communications warrants this product against defects in workmanship and material for a period of one (1) year from it's original purchase date. You must present your receipt as proof of date of purchase for warranty validation. Any unit which proves defective during the stated period will be repaired without charge for parts or labour or replaced at the sole discretion of Swann. The end user is responsible for all freight charges incurred to send the product to Swann's repair centres. The end user is responsible for all shipping costs incurred when shipping from and to any country other than the country of origin.

The warranty does not cover any incidental, accidental or consequential damages arising from the use of or the inability to use this product. Any costs associated with the fitting or removal of this product by a tradesman or other person or any other costs associated with its use are the responsibility of the end user. This warranty applies to the original purchaser of the product only and is not transferable to any third party. Unauthorized end user or third party modifications to any component or evidence of misuse or abuse of the device will render all warranties void.

By law some countries do not allow limitations on certain exclusions in this warranty.

Where applicable by local laws, regulations and legal rights will take precedence.