ADD6843 - Water filter PHILIPS - Free user manual and instructions

Product Type	Countertop water filter and dispenser
Model	ADD6843
Brand	Philips (licensed)
Dimensions (approx.)	250 x 300 x 400 mm (9.8 x 11.8 x 15.7 in)
Weight (approx.)	5.0 kg (11.0 lb)
Power Supply	AC 220-240V, 50Hz
Power Consumption	2200W (heating) / 100W (cooling)
Water Tank Capacity	3.0 L (room temperature) / 1.5 L (hot) / 1.5 L (cold)
Filtration System	Multi-stage: sediment, activated carbon, reverse osmosis, UV sterilization
Display	Digital LCD with TDS (Total Dissolved Solids) indicator
Special Modes	Winter mode (for cold climates), energy-saving mode
Water Temperature Options	Hot (≥90°C), cold (5-15°C), room temperature
Safety Features	Child lock, automatic shut-off, overheat protection, leak protection
Maintenance	Filter replacement every 6-12 months (depending on usage); descaling every 3 months
Filter Type	Philips compatible quick-change filter cartridge
Installation	No plumbing required; easy plug-and-play
Warranty	2 years (manufacturer warranty)
Certifications	CE, RoHS, NSF (for filtration)

Frequently Asked Questions - ADD6843 PHILIPS

How often should I replace the filter?

The filter should be replaced every 6-12 months depending on water quality and usage. The device will alert you when replacement is due. Use only genuine Philips filters.

How do I clean the water dispenser?

Clean the exterior with a damp cloth. For internal cleaning, run a descaling solution through the system every 3 months. Do not use abrasive cleaners.

What does the TDS display show?

The TDS (Total Dissolved Solids) display shows the purity of the filtered water in ppm (parts per million). Lower values indicate higher purity.

Can I use the dispenser without the filter?

No, the device is designed to operate only with a filter installed. Using it without a filter may damage the system and void the warranty.

What is Winter mode and when should I use it?

Winter mode adjusts the heating and cooling performance to compensate for low ambient temperatures. Activate it when room temperature falls below 10°C.

How do I reset the filter replacement indicator?

After replacing the filter, press and hold the 'Filter Reset' button (usually located on the control panel) for 3 seconds until the indicator light turns off.

Why is the water not hot enough?

Check that the heating function is activated and the water tank is filled. If the problem persists, the heating element may need servicing. Also ensure the lid is properly closed.

What should I do if the device leaks?

Immediately turn off the power and unplug the device. Check that all water tanks and drip tray are properly seated. If the leak continues, contact customer support.

Can I use the dispenser with well water?

The filter is designed for municipal tap water. Well water may contain higher levels of sediment and minerals, which could reduce filter life. Pre-treatment is recommended.

How do I activate child lock?

Press and hold the 'Child Lock' button (usually a key icon) for 2 seconds. The lock icon will appear on the display. Repeat to deactivate. The lock prevents hot water dispensing.

USER MANUAL ADD6843 PHILIPS

Instruction Manual

Table of Contents

(2) First Use

(5) Pure Water TDS Display

(12) Winter Mode

The Philips trademark and the Philips Shield Emblem are registered trademarks of Koninklijke Philips N.V. used under license. This product has been manufactured by and is sold under the responsibility of Guangdong AquaShield Health Technology Company Limited and Guangdong AquaShield Health Technology Company Limited is the warrantor in relation to this product.