NFFI-07M-600 - Drill Mondial - Free user manual and instructions
Find the device manual for free NFFI-07M-600 Mondial in PDF.
Pick your language and provide your email: we'll send you a specifically translated version.
| Product Type | Drill |
| Brand | Mondial |
| Model | NFFI-07M-600 |
| Power Consumption | 600 W |
| Rated Voltage | 220-240 V ~ 50 Hz |
| No-Load Speed | 0-2800 RPM (variable) |
| Chuck Type | Keyless, 13 mm |
| Drilling Capacity (Steel) | 13 mm |
| Drilling Capacity (Wood) | 30 mm |
| Weight | 1.8 kg |
| Dimensions (L x W x H) | 280 x 80 x 200 mm |
| Cable Length | 2.5 m |
| Forward/Reverse | Yes |
| Variable Speed Trigger | Yes |
| Lock-on Button | Yes |
| Auxiliary Handle | Included |
| Depth Stop | Included |
| Safety Features | Double insulation, lock-on button, auxiliary handle |
| Maintenance | Clean with dry cloth; check carbon brushes periodically |
| Spare Parts Available | Carbon brushes, chuck, switch, power cord |
| Included Accessories | Drill bits set (5 pcs), auxiliary handle, depth stop, chuck key (if applicable) |
Frequently Asked Questions - NFFI-07M-600 Mondial
How do I change the drill bit?
Turn the chuck counterclockwise to loosen it. Insert the bit and tighten by turning clockwise. For keyless chuck, hand-tighten firmly.
Can I use the drill for screwdriving?
Yes, the drill has variable speed and forward/reverse, suitable for screwdriving. Use screwdriver bits and set low speed.
What is the maximum drilling depth?
The maximum drilling depth depends on the bit length. With the depth stop, you can set a desired depth up to the bit's length.
How do I adjust the speed?
The speed is controlled by the trigger pressure. Press lightly for low speed, harder for higher speed. There is no speed selector switch.
Is the drill double insulated?
Yes, the drill is double insulated, so no grounding is required. Always use with a suitable power outlet.
How to clean the drill?
Unplug the drill. Wipe the exterior with a damp cloth. Do not use solvents. Keep ventilation slots clean using a soft brush.
What should I do if the drill stops working?
Check the power cord and plug. If the carbon brushes are worn, replace them. If the problem persists, contact a qualified service center.
Can I use the drill for masonry?
This drill is not a hammer drill. For masonry, use carbide-tipped bits and apply moderate pressure. For harder materials, a hammer drill is recommended.
How to replace carbon brushes?
Unscrew the brush caps on the motor housing. Remove worn brushes and insert new ones of the same size. Tighten caps and run the drill for a few minutes to seat brushes.
What accessories are included?
The drill comes with an auxiliary handle, a depth stop, a set of drill bits (5 pieces), and a chuck key (if applicable). Check the manual for full list.
User questions about NFFI-07M-600 Mondial
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
No questions yet. Be the first to ask one.
Download the instructions for your Drill in PDF format for free! Find your manual NFFI-07M-600 - Mondial and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. NFFI-07M-600 by Mondial.