3504 - Food thermometer Taylor - Free user manual and instructions

Product Type	Food Thermometer
Brand	Taylor
Model	3504
Temperature Range	-40°F to 450°F (-40°C to 232°C)
Accuracy	±1°F (±0.5°C) from -40°F to 300°F; ±2°F (±1°C) above 300°F
Display Type	Digital LCD
Probe Length	4.5 inches (11.4 cm)
Power Source	1 x CR2032 battery (included)
Dimensions (L x W x H)	2.5 x 0.75 x 6.25 inches (6.4 x 1.9 x 15.9 cm)
Weight	2.4 oz (68 g)
Auto Shut-off	After 10 minutes of inactivity
Min/Max Memory	Yes, records minimum and maximum temperature readings
Calibration	Manually calibratable using ice water and boiling water
Water Resistance	Splash-proof, not submersible
Cleaning	Wipe probe with a damp cloth; do not immerse in water
Safety	FDA approved for food contact; probe is stainless steel
Warranty	Limited 1-year warranty
Included Accessories	Sheath for probe protection

Frequently Asked Questions - 3504 Taylor

How to calibrate the Taylor 3504 thermometer?

To calibrate, prepare a glass of ice water (crushed ice and water) and a glass of boiling water. Insert the probe into the ice water without touching the glass; the reading should be 32°F (0°C). Adjust using the calibration screw if available, or note the offset. Then test in boiling water (212°F / 100°C at sea level). Repeat if necessary.

What is the temperature range of the Taylor 3504?

The thermometer measures from -40°F to 450°F (-40°C to 232°C). It is suitable for grilling, baking, and candy making.

Can the Taylor 3504 be left in the oven?

No, the Taylor 3504 is not oven-safe. The probe can withstand up to 450°F, but the display unit should never be placed inside an oven. Use only as a leave-in probe when the display is outside the heat source.

How to change the battery in the Taylor 3504?

Slide the battery compartment cover on the back of the unit. Remove the old CR2032 battery and insert a new one with the positive side facing up. Close the cover securely.

Is the Taylor 3504 waterproof?

The thermometer is splash-proof but not waterproof. Do not submerge it in water. Clean the probe only with a damp cloth and avoid getting moisture into the display unit.

How do I switch between Fahrenheit and Celsius?

Press and hold the °C/°F button for about 3 seconds until the display changes to the desired scale. The unit will remember your setting even after power off.

What does the 'MIN/MAX' function do?

The MIN/MAX function records the lowest and highest temperatures measured since the last reset. Press the MIN/MAX button to cycle through current, minimum, and maximum readings. To clear, press and hold the button for 3 seconds.

Why does my Taylor 3504 display 'LO' or 'HI'?

'LO' means the temperature is below the measurement range (-40°F), and 'HI' means it is above 450°F. Remove from extreme conditions and allow the probe to return to a safe range.

Can I use the Taylor 3504 for deep frying?

Yes, the thermometer can measure oil temperatures up to 450°F. Ensure the probe is fully inserted into the oil and not touching the bottom of the pot.

How to clean the probe after use?

Wipe the probe with a damp cloth or paper towel after each use. For heavy residues, use a mild detergent. Never wash the probe in a dishwasher or immerse the entire unit in water.

USER MANUAL 3504 Taylor

1. Thaw meat entirely before use.
2. Insert thermometer in the thickest part of the meat, 3/4" past the center, not in contact with bone, fat or gristle.
3. Adjust temperature slide reference to desired position and monitor doneness while cooking in the oven.
4. Remove meat from oven when cooked to desired temperature.

For the best results, position thermometer in these places

USDA COOKING TEMPERATURES*

RARE	140°
MED R	145°	145° WITH3 MINREST
MED	160°	160°
W DONE	170°	170°	165°	145°

**The USDA does not recommend RARE 140° as a safe cooking temperature
* Visit our website for a full list of safe cooking temperatures

CLEANING AND CARE:

Handwash only. Do not immerse in water or put in dishwasher.

ONE YEAR LIMITED WARRANTY:

Taylor warrants this product to be free from defects in material or workmanship (excluding batteries), and on return, will repair or replace it at our option, without charge.

©2019 Taylor Precision Products, a division of Lifetime Brands Inc. All rights reserved.

www.taylorusa.com | Made in China