IPAC-08KS - Air conditioner Impecca - Free user manual and instructions

Product Type	Portable Air Conditioner
Brand	Impecca
Model	IPAC-08KS
Cooling Capacity	8000 BTU (ASHRAE) / 5000 BTU (DOE)
Dehumidification	1.5 pints per hour
Fan Speeds	3 (Low, Medium, High)
Timer	24-hour programmable timer
Remote Control	Yes, with LCD display
Dimensions (W x D x H)	18.1 x 14.2 x 27.2 inches
Weight	62 lbs (28.1 kg)
Power Rating	115V AC, 60Hz, 8.5 amps
Refrigerant	R32, pre-charged
Energy Efficiency Ratio (EER)	8.5
Noise Level	Approximately 55 dB (on high speed)
Filter	Washable mesh filter
Window Kit Included	Yes (exhaust hose and adapter)
Casters	Yes, for easy mobility
Safety Features	Auto shut-off (overheat, full tank), child lock on remote
Maintenance	Clean filter every 2 weeks; drain condensate manually or via continuous drain hose
Repairability	User-serviceable filter; professional repair recommended for refrigerant or compressor
Certifications	ETL, ENERGY STAR (if applicable)

Frequently Asked Questions - IPAC-08KS Impecca

How do I install the Impecca IPAC-08KS air conditioner?

Unpack the unit, attach the exhaust hose to the back, and install the window adapter kit in a sliding or double-hung window. Secure the kit with provided screws, then plug the unit into a standard 115V outlet. Ensure the unit is level and the hose is not kinked.

How often should I clean the filter?

Clean the washable filter every two weeks under normal usage. Slide out the filter, rinse it with lukewarm water, let it dry completely, and reinstall. A dirty filter reduces cooling efficiency.

Why is my unit not cooling properly?

Check that the filter is clean, the exhaust hose is properly installed and not blocked, the room is not too large for the 8000 BTU capacity, and the thermostat is set to a lower temperature. Also ensure all windows and doors are closed.

How do I drain the water from the unit?

The IPAC-08KS uses evaporative technology, but in high humidity you may need to drain manually. Locate the drain plug at the back or bottom, place a pan, remove the plug, and let water drain. Alternatively, connect a garden hose to the continuous drain outlet.

The remote control is not working. What should I do?

Replace the batteries in the remote (CR2032). Ensure nothing is blocking the IR receiver on the unit. Point the remote directly at the unit from less than 20 feet. If still not working, try resetting the unit by unplugging it for 30 seconds.

Can I use this air conditioner in a room without a window?

No, the IPAC-08KS requires a window or similar opening for the exhaust hose to vent hot air outside. Without proper ventilation, the unit cannot cool effectively and may overheat.

What does the error code E1 or E2 mean?

Error codes typically indicate sensor issues. E1 usually means a room temperature sensor fault, while E2 indicates a coil sensor fault. Unplug the unit for 10 minutes and plug back in. If the error persists, contact Impecca support.

How do I use the timer function?

Press the TIMER button on the remote or control panel. Use the up/down arrows to set the desired hour (1-24). Press TIMER again to confirm. The unit will automatically turn on or off after the set duration.

Is the IPAC-08KS suitable for a large room?

This unit is rated at 8000 BTU (ASHRAE), which cools rooms up to about 200-250 square feet. For larger rooms, consider a higher BTU model.

What is the proper way to store the unit in winter?

Drain all water from the unit. Clean the filter thoroughly. Disconnect the exhaust hose and window kit. Store the unit in a dry, indoor location upright. Cover to protect from dust.

USER MANUAL IPAC-08KS Impecca

©

©

©

©

©

©

©

©

©

©

©

©

©

©

©

©

©

©

©

©

©

©

©

©

©