9085 - Water filter KENMORE - Free user manual and instructions

Product Type	Upright Vacuum Cleaner
Model Number	9085
Brand	Kenmore
Dimensions (Height x Width x Depth)	44 x 12 x 8 inches
Weight	12 lbs
Power Rating	12 Amps
Cord Length	25 ft
Dirt Capacity	1.5 liters (bagless)
Filtration	HEPA media filter
Cleaning Path Width	12 inches
Brush Roll	On/Off switch
Suction Control	Variable speed dial
Attachments Included	Crevice tool, dusting brush, upholstery tool
Warranty	1 year limited
Maintenance	Empty dirt cup after each use; clean filter monthly
Safety Features	Automatic shut-off when overheating
Replacement Parts	Available on Kenmore website
Repairability	User-serviceable: brush roll, belts, filters

Frequently Asked Questions - 9085 KENMORE

How do I assemble the vacuum cleaner?

Attach the handle to the main body until it clicks. Insert the hose into the port. Snap on the desired tool.

Why is my vacuum losing suction?

Check if the dirt cup is full, the filter is clogged, or the hose has a blockage. Clean or replace as needed.

How often should I clean the filter?

It is recommended to clean the filter at least once a month. Wash it with cold water and let it dry for 24 hours before reinserting.

Can I use the vacuum on hardwood floors?

Yes, the vacuum has a brush roll on/off switch. Turn off the brush roll for hardwood to avoid scratching.

How do I replace the belt?

Turn off and unplug the vacuum. Remove the bottom plate, take out the old belt, loop the new belt around the motor shaft and brush roll, then reassemble.

Why is the brush roll not spinning?

Possible causes: the belt is broken, brush roll jammed, or the brush roll on/off switch is off. Inspect and clear any obstructions.

How do I empty the dirt cup?

Press the release button to remove the dirt cup. Hold over a trash bin and press the bottom release to empty. Tap to remove debris.

What should I do if the vacuum overheats?

Turn off and unplug the vacuum. Let it cool for 30 minutes. Check for blockages and clean the filter before restarting.

Where can I purchase replacement parts?

Visit the Kenmore website or authorized dealers. Use model number 9085 to find compatible belts, filters, and brushes.

Is there a warranty on this vacuum?

Yes, Kenmore offers a 1-year limited warranty covering defects in materials and workmanship. Keep your receipt.

USER MANUAL 9085 KENMORE

PERFORMANCE DATA SHEET

Base Grille Water Filtration System

Model WF-NLC240V/46 9085 Capacity 240 Gallons (908 Liters)

System tested and certified by NSF International against NSF/ANSI Standard 42, 53, 401 and CSA B483.1 for the reduction of contaminants specified on the Performance Data Sheet.

This system has been tested according to NSF/ANSI Standards 42, 53, 401 and CSA B483.1 for the reduction of the substances listed below. The concentration of the indicated substances in water entering the system was reduced to a concentration less than or equal to the permissible limit for water leaving the system, as specified in NSF/ANSI Standards 42, 53, 401 and CSA B483.1.

Substance Reduction Aesthetic Effects	Influent Challenge Concentration	Maximum Permissible Product Water Concentration	Average % Reduction
Chlorine Taste/Odor 2.0 mg/L ± 10%	50% reduction 97.5%
Particulate Class I* At least 10,000 particles/mL	85% reduction 99.7%
Contaminant Reduction Influent Challenge Concentration Maximum		Permissible Product Water Concentration	Average % Reduction
Cysts†	50,000/L min. >99.95%	99.99%
Turbidity	11 NTU ± 1 NTU	0.5 NTU	98.9%
Asbestos	10^7 to 10^8 fibers/ L^††	>99%	99%
Lead***: @ pH 6.5	0.150 mg/L ± 10%	0.010 mg/L	99.3%
Lead***: @ pH 8.5	0.150 mg/L ± 10%	0.010 mg/L	98.8%
Mercury: @ pH 6.5	0.006 mg/L ± 10%	0.002 mg/L	95.3%
Mercury: @ pH 8.5	0.006 mg/L ± 10%	0.002 mg/L	89.7%
Atrazine	0.009 mg/L ± 10%	0.003 mg/L	94.1%
Benzene	0.015 mg/L ± 10%	0.005 mg/L	96.8%
p-Dichlorobenzene	0.225 mg/L ± 10%	0.075 mg/L	99.7%
Toxaphene	0.015 mg/L ± 10%	0.003 mg/L	93.8%
2, 4-D Reduction	0.210 mg/L ± 10%	0.07 mg/L	90.7%
Atenolol	200 ng/L ± 20% 30 ng/L	>97.0%
Linuron	140 ng/L ± 20%	20 ng/L	>96.2%
Trimethoprim	140 ng/L ± 20%	20 ng/L	>96.2%
Estrone	140 ng/L ± 20% 20 ng/L	>96.4%
Meprobamate	400 ng/L ± 20% 60 ng/L	95.0%
Carbamazepine	1400 ng/L ± 20%	200 ng/L	>98.5%
DEET	1400 ng/L ± 20%	200 ng/L	>98.5%
Metolachlor	1400 ng/L ± 20%	200 ng/L	97.0%

Test Parameters: pH = 7.5 ± 0.5 unless otherwise noted. Flow = 0.50 gpm (1.89 Lpm). Pressure = 60 psig (413.7 kPa). Temp. = 68°F to 71.6°F (20°C to 22°C). Rated service capacity, WF-NLC240V = 240 gallons (908 liters).

The compounds certified under NSF 401 have been deemed as “emerging compounds/incidental contaminants.” Emerging compounds/incidental contaminants are those compounds that have been detected in drinking water supplies at trace levels. While occurring at only trace levels, these compounds can affect the public acceptance/perception of drinking water quality.

It is essential that operational, maintenance, and filter replacement requirements be carried out for the product to perform as advertised. Property damage can occur if all instructions are not followed.
■ The disposable cartridge must be changed at least every 6 months.
■ Use replacement filter Part #46 9083. 2016 suggested retail price of \54.99 U.S.A./\54.99 Canada. Prices are subject to change without notice.
The filter monitor system measures the amount of water that passes through the filter and alerts you when it is time to replace the filter. To learn how to check the water filter status, see “Using the Controls” or “Water Filtration System” in the User Instructions or User Guide.
■ After changing the water filter, flush the water system. See “Water and Ice Dispensers” or “Water Dispenser” in the User Instructions or User Guide.
These contaminants are not necessarily in your water supply. While testing was performed under standard laboratory conditions, actual performance may vary.
■ The product is for cold water use only.
The water system must be installed in compliance with state and local laws and regulations.

Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system. Systems certified for cyst reduction may be used on disinfected waters that may contain filterable cysts. EPA Est. No. 91736-MEX-001
- Refer to the “Warranty” section for the Manufacturer’s limited warranty, name and telephone number.

Application Guidelines/Water Supply Parameters

Water Supply Potable City or Well

Water Pressure 30 - 120 psi (207 - 827 kPa)

Water Temperature 33° - 100°F (0.6° - 37.8°C)

Service Flow Rate 0.50 GPM (1.89 L/min.) @ 60 psi.

Line drawing of a cylindrical mechanical component with a flanged end (no text or symbols)

* Class I particle size: >0.5 to <1 um
*** Compliant for Lead reduction requirements under NSF/ANSI
Standard 53 as tested by Pace Analytical Services, Inc.
^ Based on the use of Cryptosporidium parvum oocysts
^++ Fibers greater than 10 m in length

® NSF is a registered trademark of NSF International.