Question 1

What should I do if the indicator light on the receiver of the FLASH THERMO DIGI 2 HF digital thermometer does not turn on?

Accepted Answer

If the indicator light on your FLASH THERMO DIGI 2 HF digital thermometer receiver does not turn on, here are the steps to diagnose and resolve this issue:

1. Check the power supply

Make sure the receiver is turned on.
If the receiver operates on batteries, check that they are properly inserted and not depleted.
If a power adapter is used, ensure that the connection is properly established and that the outlet is functioning.

2. Replace the batteries

Weak or worn batteries may prevent the indicator light from turning on. Try replacing them with new batteries to eliminate this cause.

3. Check the connection between the thermometer and the receiver

A poor connection or interference may prevent the receiver from functioning correctly:

Ensure that the thermometer and the receiver are within communication range.
Check that the devices are properly paired or synchronized according to the product instructions.

4. Reset the receiver

Perform a reset by turning off the receiver, leaving it off for a few minutes, and then turning it back on. This may resolve temporary malfunctions.

If after these checks the indicator light still does not turn on, it is possible that the receiver has a hardware defect requiring technical assistance.

Question 2

How to program a daily time slot on the FLASH THERMO DIGI 2 HF digital thermometer?

Accepted Answer

To program a daily time slot on your FLASH THERMO DIGI 2 HF digital thermometer, follow these general steps:

Steps to set a daily time slot

Turn on the device by pressing the power button.
Access programming mode by pressing the Mode or Settings button until you reach the schedule configuration option.
Select the time slot you wish to program. The device should allow you to set a start time and an end time.
Set the start time using the navigation buttons (arrows or + / -) to adjust the hours and minutes.
Set the end time in the same way.
Confirm the settings by pressing the OK or Confirm button.
Check that the programming is active and exit the settings mode by pressing Mode or Exit.

This programming will automatically apply every day, saving you from having to set it again daily. If your model offers multiple time slots, repeat these steps for each one.

Tip: Make sure that the current time on the device is set correctly before programming the time slots, as this affects the proper execution of the settings.

User manual FLASH : user manuals and guides in PDF

Models FLASH most viewed

Browse manuals FLASH by appliance type

Recent questions about devices FLASH