WPSS82W-USBAC - Bryter HAGER - Gratis bruksanvisning og manual
Finn enhetens veiledning gratis WPSS82W-USBAC HAGER i PDF-format.
Brukerspørsmål om WPSS82W-USBAC HAGER
0 spørsmål om dette apparatet. Svar på dem du kjenner, eller still ditt eget.
Still et nytt spørsmål om dette apparatet
Last ned instruksjonene for din Bryter i PDF-format gratis! Finn veiledningen din WPSS82W-USBAC - HAGER og ta den elektroniske enheten tilbake i hendene. På denne siden er alle dokumenter som er nødvendige for bruken av enheten din publisert. WPSS82W-USBAC av merket HAGER.
BRUKSANVISNING WPSS82W-USBAC HAGER
:hager
Sollysta 2 Gang 13A Switched Socket Outlet with 2 port USB charger
White Moulded / Decorative / Metalclad
Please leave this leaflet with the end user for future reference.
1
User Instructions
Contents:
A Introduction & Product Features 3
B Safety Instructions & Installation 4
C Maintenance & Disposal 4
D Guarantee 4
E Technical specifications 5
F. Customer service 6
WARNING:
To avoid possible damage to the product or spurious insulation readings, please DISCONNECT the product before carrying out INSULATON RESISTANCE TESTING
2
A. INTRODUCTION AND PRODUCT FEATURES
The USB charger is suitable for charging most portable electronic devices connected via a USB 2.0 and 3.0 type A plug or type C plug.
Twin charging ports: The USB socket comes with two charging ports capable of delivering a total maximum charging current of 3.1 A. If both USB ports are used, this max. charging current is divided between the two ports as required and controlled by the devices being charged. If only one USB ports is used, the max. charging current is 2.4 A for type A port and 3.0A for type C port
Intelligent Connection: The sollysta USB socket has built in intelligent connection, enabling the socket to identify itself as the dedicated primary charger for the connected device. This allows for maximum charging capacity and improved charging speed, as the device allows the socket to bypass its trickle/safety charging mode.
Output Overload Protection: The USB charger is protected against over-current and short circuit conditions on the output
Socket Features: Full sollysta features and benefits as per part Reference WMSS82, including patented 3 pin safety shutter system.
3
B. SAFETY INSTRUCTIONS AND INSTALLATION
The product must be installed by a professional electrician and is for indoor use only. For surface applications use WMPB2/28.
C. MAINTENANCE AND DISPOSAL
The product may be cleaned with a dry soft lint free cloth. Do not use water or any abrasive, solvent based or aerosol cleaners as this may damage or affect the finish and safety of the product.
D. GUARANTEE
Hager Ltd undertakes to replace or repair at its discretion, products should they become inoperable or defective within a period of 2 years after delivery. Goods found to be defective arising solely from faulty materials and or workmanship, must be returned to Hager Ltd. Hager Ltd must be notified of the defect or suspected defect immediately prior to return.
The Guarantee will be invalidated if the product has not been installed or maintained in accordance with the Company's instructions, has not been used appropriately or if any attempt has been made to rectify, dismantle or alter the product in any way.
4
E. TECHNICAL SPECIFICATIONS
USB Charging Ports:
| Number of ports | 2 |
| Intelligent Connection | Yes |
| USB Output Power | 15.5W |
| USB Output Voltage | 5.0 V d.c. |
| USB Output Current | 3.1A total max1 Type A port used: max. 2.4 A1 Type C port used: max. 3.0 AType A+Type A ports used:max.3.1A in totalType A+Type C ports used:max.3.1A in total |
| Average Active Efficiency | 82.00% |
| Efficiency at low load(10%) | 73.00% |
| No-load power consumption | 100 mW |
| Socket: | |
| Standard | Sockets comply with BS1363-2 |
| Input Voltage Rating | 220-240V a.c. |
| Input AC frequency | 50Hz |
| Current Rating | 13A per socket outlet |
| Terminal Capacity | 3x2.5mm2 |
| 3x4.0mm2 | |
| 2x6.0mm2 | |
| Earth | Twin Earth |
| Switching | Double pole switching mechanism |
5
Requirements for flush and surface installation.
For surface installation use mounting box WMPB2/28.
| Range | Part Reference | Min Mounting Depth with Spacer | Min Mounting Depth without Spacer | Spacer included with product |
| White Moulded | WMSS62USB xxWMSS62-USBxxxAC | — | 25mm | No |
| White Moulded | WMUSBS | 10mm USB Socket Spacer | ||
| Decorative Raised Plate | WR3BB2xxx-USBWR3BB2xxx-USBAC | — | 25mm | No |
| Decorative Flat Plate | WFSS62xxx-USBSWFSS62xxx-USB3AC | 25mm | 35mm | Yes |
| Metalclad | WPSS62x-USBWFSS62x-USBAC | — | 25mm | No |
F. CUSTOMER SERVICES
sales@hager.co.uk / technical@hager.co.uk
Hager Ltd.
Hortonwood 50
Telford
Shropshire TF1 7FT
www.hager.co.uk
6
WIS0131 Rev A