Collection MRW-200HC-2BVEF - Kello CASIO - Ilmainen käyttöohje ja opas
Löydä laitteen käyttöohje ilmaiseksi Collection MRW-200HC-2BVEF CASIO PDF-muodossa.
Käyttäjien kysymyksiä aiheesta Collection MRW-200HC-2BVEF CASIO
0 kysymys tästä laitteesta. Vastaa tuntemiisi tai esitä omasi.
Esitä uusi kysymys tästä laitteesta
Lataa ohjeet laitteellesi Kello PDF-muodossa ilmaiseksi! Löydä käyttöohjeesi Collection MRW-200HC-2BVEF - CASIO ja ota elektroninen laitteesi takaisin hallintaan. Tällä sivulla julkaistaan kaikki laitteidesi käyttöön tarvittavat asiakirjat. Collection MRW-200HC-2BVEF merkiltä CASIO.
KÄYTTÖOHJE Collection MRW-200HC-2BVEF CASIO
Operation Guide ANA (MAA)
CASIO
- Your watch may differ somewhat from the one shown in the illustration.
Notes
Some water resistant models are equipped with a screw lock • crown.
- With such models, you must unscrew the crown in the direction noted in the illustration to loosen it before you can pull it out. Do not pull too forcibly on such crowns.
- Also note that such watches are not water resistant while their crowns are loosened. Be sure to screw the crowns back in as far as they will go after making any setting.
[Module 5128]
To set the time
- When the second hand is at 12 o'clock, pull out the crown to the second click to stop it. Set the hands by rotating the crown. Move the 2. minute hand four or five minutes past the setting you want, and then back them up to the setting. Push the crown back in on a time signal to resume 3 timekeeping.
To set the day
- Avoid setting the day between 9:00 p.m. and 1:00 a.m. The day may not change in the following day if you do.
Pull out the crown to the first click.1. - Set the day by rotating the crown. Push the crown back in to its normal position.3.
[Module 5125]
To set the time
When the second hand is at 12 o'clock, pull out the 1. crown to the second click to stop it. Set the hands by rotating the crown. Move the 2. minute hand four or five minutes past the setting you want, and then back them up to the setting. Push the crown back in on a time signal to resume 3. timekeeping.
To set the day and day of the week
Avoid setting the day and day of the week between 9:00 p.m. and 5:00 a.m. The day and day of the week may not change in the following day if you do. Pull out the crown to the first click.1. Set the day by rotating the crown counterclockwise.2 Set the day of the week by rotating the crown clock. Push the crown back in to its normal position.4.
For watch with the elapsed time bezel •
Rotate the elapsed time bezel to align the ▼ mark with the minute hand.
After certain amount of time elapsed, read the graduation on the elapsed time bezel which the minute hand points to. The elapsed time is indicated.
Elapsed time bezel
Specifications
| Module No. | Accuracy at normal temperature (per month) | Battery type Battery life |
5125/5128 ±20 seconds SR626SW Approx. 3 years
