PMPC01 - Câbles pour ordinateurs et périphériques Nordväl - Free user manual and instructions

USER MANUAL PMPC01 Nordväl

Parking mode cable set

PMPC01

Three coiled electrical wires with a central indicator box, no visible text or symbols

English Quick start guide

Notification:

The company is not responsible for any damage caused by not following this manual.

Read the complete manual before installing the cable set.

NORDVAL

Make sure the vehicle's engine is turned off

The location and layout of the fuse panel and the type of fuses used depend on the vehicle.

Connect the red ACC (+) to the fuse panel

Check your car owner's manual to find out where the fuse panel is located. Remove the cover from the fuse panel. Remove a switched fuse from the fuse panel like, for example, the audio system or cigarette lighter. Reinstall the red ACC (+) in the fuse panel where the switched fuse was just removed.

Connect the yellow BATT (+) to the constant power connection

Remove a constant supply fuse from the fuse panel like, for example, the hazard light, rear light, or interior lighting. Replace the yellow BATT (+) in the fuse panel where the constant power fuse was just removed. If the car uses a battery storage function (Battery Saver Function), make sure that the yellow BATT (+) wire is connected to the location of the hazard light.

Connect the black GND wire to a grounding point

Attach the GND wire to a grounding point, such as a bolt, located directly on a metal part of the vehicle frame.

Connect the micro-USB cable to the Nordväl dashcam

Place the dashcam in the correct position on the front window of the vehicle. Plug the micro-USB cable into the dashcam.

Start the engine and check that the dashcam turns on and continues to record once the car is turned off.

Electrical control panel with multiple color-coded blocks and wiring, no visible text or symbols

Close-up of electrical wiring and components with no visible text or symbols