Mini Monitor v1 - Pregnant Paradigm - Free user manual and instructions

Product Type	Bookshelf Speaker
Brand	Paradigm
Model	Mini Monitor v1
Configuration	2-way Bass Reflex
Woofer	6.5" (165 mm) Mineral-Filled Polypropylene
Tweeter	1" (25 mm) Pure Aluminum Dome Ferrofluid-Cooled
Frequency Response	60 Hz - 20 kHz ± 2 dB
Impedance	8 Ohms
Sensitivity	88 dB / 2.83 V / 1 m
Power Handling (Continuous)	100 W RMS
Crossover Frequency	3 kHz
Dimensions (H x W x D)	14.5" x 8.5" x 10.25" (368 x 216 x 260 mm)
Weight	16 kg (7.3 kg)
Finish Options	Black Ash, Cherry, Rosemont
Connectivity	Bi-wireable Gold-Plated Binding Posts
Recommended Amplifier Power	15 - 150 W per channel
Warranty	5 Years (Driver), 2 Years (Electronics)
Cleaning	Wipe with a soft, dry cloth. Avoid harsh chemicals.
Safety	Place on stable surface; keep away from moisture.
Repairability	Replaceable drivers and crossover available.

Frequently Asked Questions - Mini Monitor v1 Paradigm

What is the best placement for Paradigm Mini Monitor v1 speakers?

Place them at ear level when seated, at least 2 feet from the back wall and 1 foot from side walls to avoid boundary reflections. Angle them slightly towards the listening position for optimal imaging.

Can I use the Mini Monitor v1 as a center channel?

While designed as a bookshelf speaker, you can use a single Mini Monitor v1 horizontally as a center if space allows. However, for best results, use a dedicated center channel speaker.

What amplifier power is recommended?

These speakers handle 15-150 watts RMS per channel. An amplifier with 50-100 watts is ideal for most listening levels.

How do I clean the speaker grills and cabinet?

For the cabinet, use a soft, dry microfiber cloth. For grills, vacuum gently with a brush attachment or remove and wash with mild soap and water, then air dry.

Is the Paradigm Mini Monitor v1 a shielded speaker?

No, these are not magnetically shielded. Keep them at least 12 inches away from CRT televisions or older monitors to avoid discoloration.

Can I bi-wire or bi-amp these speakers?

Yes, the binding posts allow bi-wiring. Remove the gold jumpers between terminals to split the signal. For bi-amping, use two separate amplifier channels.

What is the break-in period for these speakers?

Expect 20-50 hours of moderate use for the drivers to loosen and reach optimal performance. You may notice improved bass and smoothness.

Why is there no sound coming from one speaker?

Check speaker wire connections, amplifier balance, and if the issue persists, swap cables between speakers to identify if the problem is with the speaker or amp. Also inspect the fuse (if any).

What type of speaker wire should I use?

Use 16-14 AWG stranded copper wire for runs up to 50 feet. Ensure proper polarity: red to positive, black to negative.

Are replacement parts available for the Mini Monitor v1?

Yes, Paradigm offers replacement drivers, tweeters, and crossovers through authorized dealers. Check the product number on the back or contact support.

USER MANUAL Mini Monitor v1 Paradigm

Congratulations, you are about to hear the difference a musically accurate speaker makes in your audio/home theater system. Please take a few moments to read this manual. Follow all instructions to ensure proper installation and operation for maximum listening enjoyment.

Comprehensive R&D has been undertaken to achieve optimum performance of every individual component part at every design stage. This has enabled PARADICM to produce speaker systems that have outstanding musical ability and unprecedented value!

Use of the finest components and materials along with sophisticated manufacturing and quality control techniques ensure that this exceptional level of performance will be maintained for many years.

Your speakers are finished in high quality vinyl woodgrain veneer which is both attractive and durable. To clean use a damp, soft cloth. Do not use a strong or abrasive cleaner. Avoid getting any part of the speaker system wet.

NOTE!

If your PARADIGM speakers have been transported or stored at temperatures below 10°C (50°F) they should be allowed to warm up to normal room temperature before using, otherwise performance may be affected. This is because of two factors:

1. The surround material used in the bass/midrange drive unit is made of a compound that may stiffen in colder temperatures.

2. The ferro-fluid used in the tweeter thickens in colder temperatures.

Although PARADIGM speakers sound great "right out of the carton", they will sound even better after they are "broken-in". We therefore recommend that you operate the speakers for several hours before you do any critical listening.

YOUR LISTENING ROOM

PARADEM speakers have been designed to provide excellent musical results in a wide variety of domestic settings. It is important to note however, that listening room construction, dimensions and furnishings all play a part in the quality of sound you will ultimately achieve. Your listening room will impose its own character on the performance capabilities of any speaker system. The extra care you take in setting-up PARADEM speakers in your room will result in greater musical enjoyment. Please consider and try to follow these guidelines:

a) Concrete floors and walls (i.e. basement rooms) tend to aggravate low frequency standing wave problems and are less preferred.

b) Mid and high frequencies are affected by the amount of soft furnishings in your room such as curtains, carpets, sofas, wallcoverings, etc. An excess of such items can produce a duller sound. The same room without any soft furnishings will produce a brighter sound. A "normal" quantity of soft furnishings found in most living situations provides the right acoustic space so that the speaker will sound balanced.

SPEAKER LOCATION

PARAIGN speakers are designed to allow flexible placement and provide a very large "window" of sound into your listening room. To optimize performance, however, we do suggest that you observe these guidelines:

a) Accurate Timbre: The most accurate timbrel balance will be achieved with the tweeters at approximately ear level. To help accommodate this we recommend PREMIER™ speaker stands. (See your dealer for more information)

IN CANADA: PARADIGN ELECTRONICS INC. 101 HAMILAN RD., WOODBRIDGE, ON L4L3P6 IN THE U.S: AUDIOSTREAM, MPO BOX 2416, NIAGARA FALLS, NY 14302 CM-10

© PARADIGM ELECTRONICS INC.+BAVAN CORPORATION

PRINTED IN CANADA

REV.01.98

b) Optimized Imaging: Measure the approximate distance from your listening position to the speakers. The speakers should be positioned approximately 2/3 of that distance from each other. (For example, if the listening-position to speakers-position distance is -lm (5ft) then the speakers should be -2m (6ft) apart.) Turning the speakers so they are "aimed" toward the listening position can also enhance imaging ability.

c) Bass Performance: As a general rule placing speakers closer to the rear wall increases low bass output (this is true for front ported, rear ported or sealed enclosures). For optimal bass performance the speakers should be positioned so that the distance to the side walls is different than the distance to the rear wall. Avoid corner placement as this usually produces excessive bass and reduces clarity.

CONNECTION

Be sure your amplifier is switched off before connecting your speakers. This will avoid damage which may result from accidental shorting of speaker cables.

For optimum sound reproduction the use of high-quality speaker cable is essential. We recommend AUDIOSTREAM™ speaker cables. The following chart identifies minimum gauge requirements for various lengths: (See your dealer for more information)

Length	Diameter	Gauge
Under 4.5m (15ft)	2.3 mm	16 aug
Under 9m (30ft)	1.6 mm	14 aug
Over 9m (30ft)	2.0 mm	12 aug

Correct polarity (or phase), is critical for proper stereo imaging and bass performance. If you hear a distinct lack of bass and a dislocated stereo image, then your speakers are most likely connected out of phase. Be careful! Connect one speaker at a time to ensure proper connection of left and right channels. The red (+) amplifier terminal must be connected to the red (+) PARADGM speaker terminal. The same applies to the black (-) terminals. Make sure all wires are firmly fastened.

PREVENTING SPEAKER DAMAGE

PARADIGM speakers are efficient and can be driven to loud listening levels with moderate amplifier power. They are also able to handle the output of very powerful amplifiers.

Amplifier Distortion - The #1 Culprit!

Amplifier distortion is the principal cause of speaker damage. When listening at loud levels your amplifier may run out of clean power. It will then begin to produce distorted power several times greater than its rated output power. This will damage any brand of speaker very quickly!

More Powerful Amplifiers are Safe

A 40 watt/channel amplifier will have substantial distortion above 40 watts. If driven to 50 watts, this amplifier will deliver distorted power - which will damage the speaker: A 100 watt/channel amplifier will have substantial distortion above 100 watts, but very low distortion below 100 watts. Thus, when the speaker requires 50 watts, this more powerful amplifier will deliver clean power and speaker damage is less likely to occur.

The Volume Control

Do not be fueled by the Volume Control of your Receiver/Preamplifier. It only adjusts listening level - it is not a "power-output" dial. The amount of amplifier power actually used at a given Volume Control setting depends solely on the nature of the music; you are listening to. At a given Volume Control setting, a quiet section of music will use less amplifier power than a loud section. With typical pep-rock, jazz or large scale classical music, the rated output power of many receivers/amplifiers can often reached when the control is between the "11 and 1 o'clock" setting (with bass/inble and lodger controls not used - otherwise rated power may be reached at even lower Volume Control settings).

Remember, all amplifiers produce distortion when operated beyond their rated output power. The resulting distortion will damage all speakers! Exercise caution! If you listen at loud levels, be careful to listen for the point of audible distortion... if the speakers begin to sound distressed turn the Volume Control down or your speakers and/or amplifier(s) will be damaged! If louder volumes are desired obtain a more powerful amplifier.

There is a Limit!

Although more powerful amplifiers are safer, there is a point at which you could have more power than the speaker can handle. At that point you will overpower the speaker and damage it. Exercise caution! At loud levels do not increase bass/treble controls from zero and ensure that all loudness/contour/bass EQ buttons are off (otherwise rated output power will be reached at lower volume control settings). If you listen at loud levels, watch

for excessive visible cone excursion (grill movement) from the woofer...then turn the Volume Control down.

The Right Amount of Power

A power-range rating is given as a guide to indicate the minimum and maximum power input, approximately, of your PARADIGM speakers. Amplifiers that exceed your speaker's power-range rating are, in fact, recommended. Their greater power reserves provide better sound. However, exercise caution! Use the speakers within their power-range rating to prevent damage (keep listening levels below the point of excessive woofer cone excursion).

WARRANTY

PARAEGM speakers covered by this manual are warranted to be and remain free of manufacturing and/or material defects for a period of 5 years from the date of the original retail purchase. Within this specified period, repair, replacement or adjustment of parts for manufacturing and/or material defects will be free of charge. (Retain this manual for proof of warranty term).

Note: Thermal damage is not covered by warranty.

Limitations:

- Warranty begins on date of original retail purchase from an AUTHORIZED PARADISM DEALER only. It is not transferable.

• Warranty applies to product in normal home use.

- Warranty does not apply if the product is used in professional or commercial

applications

Warranty is Void if:

• The speaker has been abused (intentionally or accidentally).

• The speaker has been used in conjunction with unsuitable or faulty equipment.

• The speaker has been subjected to damaging signals, derangement in transport.

mechanical damage or any abnormal conditions.

• The speaker (including cabinet) has been tampered with or damaged by an

unauthorized service facility

• The serial number plate has been removed or defaced.

Owner Responsibilities:

- Provide normal/reasonable operating care and maintenance.

- Provide proof of purchase (your sales receipt given at time of purchase from your

AUTHORIZED PARADIGM DEALER must be retained for proof of purchase-date).

- Provide or pay for transportation charges for product to service facility

Should servicing he required contact your nearest AUTHORIZED PARADIGM DEALER, PARADIGM ELECTRONICS INC. (in Canada), AUDIOSTREAM, DIVISION OF BANAN CORPORATION (in the U.S.) or IMPORT DISTRIBUTOR (outside the U.S. and Canada) to arrange, bring in or ship, prepaid, any defective unit.

PARADIGM ELECTRONICS INC. reserves the right to improve the design of any product without assuming any obligation to modify any product previously manufactured.

This warranty is in lieu of all other warranties expressed or implied, of merchantability, fitness for any particular purpose and may not be extended or enlarged by anyone. In no event shall PARADIGM ELECTRONICS INC., their agents or representatives be responsible for any incidental or consequential damages. Some jurisdictions do not allow limitation of incidental or consequential damages, so this exclusion may not apply to you.

Paradigm

© PARADIGM ELECTRONICS INC.+EMIAN CORPORATION